Using compression molding to form lenses over LED arrays on a metal core printed circuit board leaves a flash layer of silicone covering the contact pads that are later required to connect the arrays to power. A method for removing the flash layer involves blasting particles of sodium bicarbonate at the flash layer. A nozzle is positioned within thirty millimeters of the top surface of the flash layer. The stream of air that exits from the nozzle is directed towards the top surface at an angle between five and thirty degrees away from normal to the top surface. The particles of sodium bicarbonate are added to the stream of air and then collide into the top surface of the silicone flash layer until the flash layer laterally above the contact pads is removed. The edge of silicone around the cleaned contact pad thereafter contains a trace amount of sodium bicarbonate.