摘要:
A lighting apparatus for a high-pressure discharge lamp that has an electric discharge container made of quartz glass, and containing a pair of counter electrodes and a power supply unit that supplies AC current to the high-pressure discharge lamp. The power supply unit has a stationary power lighting mode and a modulated power lighting mode that supplies current having power less than power in the stationary power lighting mode. The modulated power lighting mode supplies a rectangular AC current having a first term and a second term. A mean high-frequency current value supplied to a first electrode is greater than a mean current value supplied to a second electrode in the first term. A current is supplied to the second electrode for a term longer than the half-cycle period in the second term, the current being lower than the mean high-frequency current value supplied to the first electrode.
摘要:
A discharge lamp lighting apparatus for lighting a discharge lamp where a voltage generated in a secondary side winding can be superimposed on an output voltage of an inverter and is impressed between electrodes, where while a periodic drive circuit generates an inverter drive signal so that frequency of the inverter becomes a start-up initial frequency, electric supply control circuit controls a power supply circuit to output no-load opening voltage, where the frequency of the inverter gradually decreases until reaching a first threshold frequency from the start-up initial frequency, where when the frequency of the inverter reaches the first threshold frequency, the periodic drive circuit generates the inverter drive signal so that the frequency of the inverter becomes stable lighting frequency, and where the electric supply control circuit controls the power supply circuit to output current which is sufficient to maintain electric discharge of the discharge lamp.
摘要:
The present discharge lamp lighting device is capable of rapid modulation in which a lamp current is rapidly reduced and rapidly restored. The current control circuit is provided to perform specific current control such that the brightness of a lamp is reduced by a predetermined percentage without being affected by a variation or change in lamp voltage over time, thereby reducing a lamp current.
摘要:
A low cost DC-DC converter facilitates a reduction of the switching loss in the wide, variable range of the continuity ratio for a main switching device. The DC-DC converter includes a direct current source, an ON-OFF-controllable main switching device, a main coil which is series connected to the main switching device, a fly-wheel diode which is arranged such that the induction current of the main coil flows when the main switching device is shifted into the OFF state, and a smoothing capacitor for smoothing the output of the main coil, Also included is an auxiliary transformer with a primary winding as a direct current source and a secondary winding. The main switching device and the auxiliary switching device are controlled such that they are shifted alternatively into the ON state, and the main switching device, is shifted into the ON state a given time after the auxiliary switching device has been shifted into the OFF state.
摘要:
A low cost DC-DC converter which facilitates a reduction of the switching loss in a wide, variable range of the continuity ratio of the main switching device includes a direct current source; an ON-OFF-controllable main switching device; a main coil which is series connected to the main switching device; a fly-wheel diode which is arranged such that the induction current of the above described main coil flows when the main switching device is shifted into the OFF state; a smoothing capacitor for smoothing the output of the main coil; an auxiliary coil, a resonant capacitor and an ON-OFF-controllable auxiliary switching device. The main switching device and the auxiliary switching device are controlled such that each are alternatively shifted into the ON state such that the main switching device is shifted into the ON state within a given time after the auxiliary switching device has been shifted into the OFF state.
摘要:
The purpose of the present invention is to make it possible to output stable light by optimizing the wavelength conversion efficiency in a wavelength conversion element without employing an optical detection device such as a photo diode in a laser light source device. A fundamental light wave emitted from a semiconductor laser (2) is wavelength converted by a wavelength conversion element (5) and is emitted therefrom. A lighting circuit (20) supplies electric power for the aforementioned semiconductor laser (2) to turn on the semiconductor laser (2). A control unit (21) controls the operation of the device while controlling the amount of power supplied to a heater means (7) such that the wavelength conversion element (5) reaches a temperature at which optimum wavelength conversion efficiency is acquired. The temperature detected by a temperature detection means (Th1) is input to the control unit (21), and the control unit (21) defines the temperature of the wavelength conversion element (5) at which the maximum amount of power is supplied to the heater means (7) as a set temperature at which the optimum wavelength conversion efficiency is acquired, and performs feedback control of the temperature of the wavelength conversion element (5) so that the temperature of the wavelength conversion element (5) reaches the aforementioned set temperature by controlling the amount of heat supplied from the heater means (7).
摘要:
In a discharge lamp lighting apparatus, in a starting sequence of a discharge lamp, while a frequency control circuit generates a inverter driving signal corresponding to resonance frequency of a resonant circuit, a power supply circuit outputs non-load open circuit voltage that is sufficient to maintain electric discharge, even when a boosting action accompanying a resonance phenomena disappears, and then a periodic drive circuit generates the inverter driving signal to gradually decrease frequency of the inverter from a frequency corresponding to the resonance frequency of the resonant circuit, until the frequency of the inverter reaches a first threshold frequency, and wherein when the frequency of the inverter reaches the first threshold frequency, while the periodic drive circuit generates the inverter driving signal so that the frequency of the inverter turns into a stable lighting frequency, the power supply circuit outputs current that is sufficient to maintain the electric discharge of the discharge lamp.
摘要:
In a discharge lamp lighting apparatus, in a starting sequence of a discharge lamp, while a frequency control circuit generates a inverter driving signal corresponding to resonance frequency of a resonant circuit, a power supply circuit outputs non-load open circuit voltage that is sufficient to maintain electric discharge, even when a boosting action accompanying a resonance phenomena disappears, and then a periodic drive circuit generates the inverter driving signal to gradually decrease frequency of the inverter from a frequency corresponding to the resonance frequency of the resonant circuit, until the frequency of the inverter reaches a first threshold frequency, and wherein when the frequency of the inverter reaches the first threshold frequency, while the periodic drive circuit generates the inverter driving signal so that the frequency of the inverter turns into a stable lighting frequency, the power supply circuit outputs current that is sufficient to maintain the electric discharge of the discharge lamp.
摘要:
A discharge lamp lighting apparatus for lighting a discharge lamp, comprises an inverter which reverses a polarity of an output voltage and applies alternating voltage to the discharge lamp, and an inverter control circuit which generates an inverter control signal defining a polarity reversal operation of the inverter, based on a polarity reversal timing signal, wherein when the number of polarity reversals in one cycle of the polarity reversal timing signal is even, the inverter control circuit intermittently performs a first operation in which successive pulse-like part of the polarity reversal operation based on the polarity reversal timing signal is disregarded by odd number of times.
摘要:
A solid product removal method for removing a solid product adhering to a gas exhaust pipe member having a rinsing water inlet pipe member with a tip opening located inside the gas exhaust pipe member for feeding rinsing water into the inside of the gas exhaust pipe member from the tip opening thereof; hence a solid product formed newly upon reaction with the rinsing water and adhering thereto can be rinsed off with the rinsing water introduced from another tip opening located at a different position; and therefore, an adherence of the solid product can be prevented from heating the inner face of the gas exhaust pipe member. A scraping member for scraping the solid product stuck to the inner face of the gas exhaust pipe member may be used.