公开(公告)号：US20080130798A1

公开(公告)日：2008-06-05

申请号：US11970653

申请日：2008-01-08

Applicant: Takeshi Ohba ,  Yasuhito Funyu ,  Hideharu Shako

Inventor： Takeshi Ohba ,  Yasuhito Funyu ,  Hideharu Shako

IPC: H04L27/06

CPC classification number: H03F1/3247 ,  H03F1/3294 ,  H03F2201/3233

Abstract: In a delay regulating device, delay regulation is performed using a delay circuit performing delay regulation in a clock unit and a delay filter performing delay regulation in a tap unit smaller than the clock unit. The delay regulation is performed so as to obtain the maximum value of the correlation value and the minimum value of the error signal. First the delay circuit based on the clock unit is used to control the delay amount of the reference signal so as to obtain the maximum value of the correlation value. The delay filter is used to control the delay amount of the feedback signal so as to obtain the maximum value of the correlation value. Phase adjustment of the reference signal and the feedback signal is performed. The delay amount of the feedback signal is regulated so as to minimize the error signal unit using the delay filter.

Abstract translation: 在延迟调节装置中，使用在时钟单元中执行延迟调节的延迟电路和在小于时钟单元的抽头单元中执行延迟调节的延迟滤波器来执行延迟调节。 执行延迟调节以获得相关值的最大值和误差信号的最小值。 首先，使用基于时钟单元的延迟电路来控制参考信号的延迟量，以获得相关值的最大值。 延迟滤波器用于控制反馈信号的延迟量，以获得相关值的最大值。 执行参考信号和反馈信号的相位调整。 调整反馈信号的延迟量，以便使用延迟滤波器使误差信号单元最小化。

公开(公告)号：US20080002983A1

公开(公告)日：2008-01-03

申请号：US11589898

申请日：2006-10-31

Applicant: Hiroyoshi Ishikawa ,  Nobukazu Fudaba ,  Hajime Hamada ,  Kazuo Nagatani ,  Yasuhito Funyu ,  Norio Tozawa ,  Tokuro Kubo

Inventor： Hiroyoshi Ishikawa ,  Nobukazu Fudaba ,  Hajime Hamada ,  Kazuo Nagatani ,  Yasuhito Funyu ,  Norio Tozawa ,  Tokuro Kubo

IPC: H04B10/00

CPC classification number: H03F1/0266 ,  H03F1/0205 ,  H03F1/0244 ,  H03F1/32 ,  H03F3/24

Abstract: A bias control signal generation unit detects ON and OFF of a transmission signal input to an amplifier and having a property of a burst according to burst information. The bias control signal generation unit controls a bias voltage to be applied to an amplifier such that an idle current flowing through the amplifier can be flowing in a larger amount in a transmission OFF period, and can return to a normal level in a transmission ON period.

Abstract translation: 偏置控制信号生成单元根据突发信息检测输入到放大器的发送信号的接通和关断，并具有突发的性质。 偏置控制信号发生单元控制要施加到放大器的偏置电压，使得流过放大器的空闲电流可以在传输关闭时段内以较大的量流动，并且可以在传输开启周期中恢复到正常电平 。

公开(公告)号：US20070253566A1

公开(公告)日：2007-11-01

申请号：US11504503

申请日：2006-08-15

Applicant: Hideharu Shako ,  Yasuhito Funyu ,  Takeshi Ohba

Inventor： Hideharu Shako ,  Yasuhito Funyu ,  Takeshi Ohba

IPC: A61F11/06

CPC classification number: H03F1/3247 ,  H03F1/3294 ,  H03F3/24 ,  H03F2200/321 ,  H03F2200/336 ,  H03F2200/451 ,  H03F2201/3233 ,  H04L27/368

Abstract: The present apparatus includes: distortion amount detector which detects the amount of distortion of an output signal of the amplifier; parameter holder; parameter corrector which corrects a parameter held in the parameter holder in such a manner that the distortion amount detected by the distortion amount detector is improved; controller which controls frequency components to be subjected to distortion amount detection that is performed by the distortion amount detector, based on the distortion amounts of a plurality of different frequency components of the output signal of the amplifier and on specification values relating to the distortion amounts. This arrangement makes it possible to set (control) appropriate distortion data measurement point (frequency component to be detected) according to multiple specification values (for example, ACLR specification values) relating to the distortion amount.

Abstract translation: 本装置包括：失真量检测器，其检测放大器的输出信号的失真量; 参数持有人 参数校正器，其以使得由失真量检测器检测到的失真量提高的方式校正参数保持器中保持的参数; 控制器，其基于失真量检测器执行的失真量检测的频率分量，基于放大器的输出信号的多个不同频率分量的失真量和与失真量相关的规格值来控制。 这种布置使得可以根据与失真量相关的多个规格值（例如，ACLR规范值）来设置（控制）适当的失真数据测量点（要检测的频率分量）。

公开(公告)号：US07274914B2

公开(公告)日：2007-09-25

申请号：US11018258

申请日：2004-12-21

Applicant: Takeshi Ohba ,  Yasuhito Funyu ,  Hiroaki Abe ,  Tomohiro Nakamura

Inventor： Takeshi Ohba ,  Yasuhito Funyu ,  Hiroaki Abe ,  Tomohiro Nakamura

IPC: H04B1/00

CPC classification number: H04L27/2614

Abstract: A power correction value generating unit determines a power correction value for minimizing an error, from a reference output power value of a carrier multiplexed signal, generating due to peak power suppression under a carrier setting based on the carrier setting relating to either one or both of the number of carrier signals and frequency arrangement, and peak suppression setting. An output power error correcting unit corrects a signal gain before or after the carrier signals are multiplexed, using the power correction value obtained by the power correction value generating unit. In an apparatus performing peak suppression according to an input limitation power of the power amplifier, it is possible to always obtain a desirable transmission (output) power even when the number of carriers or carrier frequency arrangement varies.

Abstract translation: 功率校正值生成单元根据载波复用信号的基准输出功率值，根据载波设定下的峰值功率抑制而产生的误差最小化的功率校正值，基于与 载波信号的数量和频率排列以及峰值抑制设置。 输出功率误差校正单元使用由功率校正值生成单元获得的功率校正值来校正载波信号被复用之前或之后的信号增益。 在根据功率放大器的输入限制功率进行峰值抑制的装置中，即使当载波数或载波频率布置发生变化时，也可以总是获得期望的传输（输出）功率。

公开(公告)号：US20060029155A1

公开(公告)日：2006-02-09

申请号：US11113043

申请日：2005-04-25

Applicant: Hideharu Shako ,  Yasuhito Funyu ,  Takeshi Ohba

Inventor： Hideharu Shako ,  Yasuhito Funyu ,  Takeshi Ohba

IPC: H04L25/03

CPC classification number: H03F1/3247

Abstract: To shorten the time required for writing of the distortion compensation coefficient and to reduce amount of data of the distortion compensation coefficient stored as the initial value of the distortion compensation apparatus. The distortion compensation apparatus for amplifying the transmitting signal after implementing the distortion compensation process comprises a coefficient memory for storing corresponding to each address the coefficient used for the distortion compensation process, an initial value memory for storing the initial value of the coefficient, and a controller for write control corresponding to n (n: natural number equal to 2 or larger) addresses of the coefficient read from the initial value memory corresponding to one address.

Abstract translation: 缩短写入失真补偿系数所需的时间并减少作为失真补偿装置的初始值存储的失真补偿系数的数据量。 用于在实施失真补偿处理之后放大发送信号的失真补偿装置包括用于存储对应于每个地址的用于失真补偿处理的系数的系数存储器，用于存储系数的初始值的初始值存储器，以及控制器 对应于从对应于一个地址的初始值存储器读取的系数的n（n：等于2或更大的自然数）的地址的写入控制。

公开(公告)号：US20050164656A1

公开(公告)日：2005-07-28

申请号：US10840700

申请日：2004-05-06

Applicant: Masayuki Watabe ,  Yasuhito Funyu ,  Hiroaki Abe ,  Hisato Kawano

Inventor： Masayuki Watabe ,  Yasuhito Funyu ,  Hiroaki Abe ,  Hisato Kawano

IPC: H04B1/707 ,  H03F1/32 ,  H03F3/24 ,  H04B1/04 ,  H04J13/00 ,  H04L27/26 ,  H04L27/36

CPC classification number: H03F1/3247 ,  H03F1/3294 ,  H03F2201/3206 ,  H03F2201/3233 ,  H04B1/707 ,  H04L27/368

Abstract: In a network employing code division multiplex access, a distortion compensation amplifying apparatus is provided which is capable of making quick response to carry out the distortion compensation with high accuracy even if the signal power to be inputted thereto varies rapidly. In this distortion compensation amplifying apparatus, the renewal of a distortion compensation coefficient in a renewing unit is complemented on the basis of a result of amplification in an amplifier with respect to a signal code-division-multiplexed in a pseudo-signal multiplexing unit.

Abstract translation: 在采用码分复用接入的网络中，提供了一种失真补偿放大装置，其能够进行快速响应，即使要输入的信号功率迅速变化，也能够以高精度执行失真补偿。 在该失真补偿放大装置中，相对于在伪信号复用部中的信号码分解多路复用的放大器的放大结果，对更新单元中的失真补偿系数的更新进行补充。