摘要:
An apparatus for measuring phase angle difference between two conductors uses a hot stick, a field unit, and reference unit. Voltage is sensed at a conductor, and the voltage is passed through an automatic gain control which adjusts the voltage input to a voltage detector to a level which prevents saturation of the voltage detector. Non-saturation of the voltage detector enables detection of all of the data in a detected sine wave. Pulse width modulation and pulse width modulation RF transmission are used to provide for data transmission from a hot stick to a field unit.
摘要:
A method for detecting loss of SF6 gas from electrical utility apparatus determines a molar ratio of gas in a container at an initial time and of gas in the container at a subsequent time. Measurement of temperature is determined by averaging ambient temperature and temperature of the surface of the container. The initial values of pressure and temperature define the initial value of n as follows: no=Pgas o/Tgas oThe value at a subsequent time is nn=Pgas n/Tgas nThe molar ratio can be defined as nn/no or as no/nn
摘要翻译:用于检测来自电力设备的SF6气体的损失的方法确定在初始时间的容器中的气体与随后的容器中的气体的摩尔比。 温度的测量通过平均容器表面的环境温度和温度来确定。 压力和温度的初始值定义如下的初始值n:<?in-line-formula description =“In-line Formulas”end =“lead”?> n sub> = P < α-in-line-formula description =“In-line Formulas”end =“tail”?>随后时间的值为<? in-line-formula description =“In-line Formulas”end =“lead”?> n sub> n sub>气体n SUB > <?in-line-formula description =“在线公式”end =“tail”?>摩尔比可以定义为<?in-line-formula description =“In-line Formulas”end =“lead” α> n sub> / n sub>或者作为第n个/ =“内联公式”end =“tail”?>
摘要:
Methods for the prediction of the frequency of high order resonant ultrasound spectroscopy (RUS) diagnostic modes are used to limit the band width of diagnostic testing at high order mode frequencies. Testing of parts at low order frequency modes is used to calculate part dimensions, and then these calculated part dimensions are used to predict high order diagnostic mode frequencies. Lower order mode frequencies are used to predict high order diagnostic mode frequencies.
摘要:
Methods for the prediction of the frequency of high order resonant ultrasound spectroscopy (RUS) diagnostic modes are used to limit the band width of diagnostic testing at high order mode frequencies. Testing of parts at low order frequency modes is used to calculate part dimensions, and then these calculated part dimensions are used to predict high order diagnostic mode frequencies. Lower order mode frequencies are used to predict high order diagnostic mode frequencies.