Abstract:
This invention enables determining whether a received frame is an erasure, a DTX mode frame or a CONT mode frame, using a metric m derived from the log likelihood ratio (LLR). The new metric is obtained by calculating the mean for the LLRs for a frame; a threshold T for this metric is also established. A received frame is declared a CONT frame if the CRC value indicates a successfully recovered frame, and m>T. A received frame is a DTX frame if m T. The mean absolute LLR may also be used for determining the transmission rate of the system. In this case, a voice frame is decoded for all rates available; the transmission rate is that which corresponds to a passed CRC and has the highest m.
Abstract:
The present application proposes an airborne electromagnetic signal observation device and a system carried by an unmanned aerial vehicle (UAV). The device includes an inner frame, an outer frame and a flexible support that are connected to each other. The device and the system can enhance the stability of the sensor in flight and greatly suppress motion noise.
Abstract:
A method of connection setup in mobile wireless data communications systems is disclosed where the connection setup time is decreased for delay-sensitive communications sessions relative to the normal connection setup time for confidence-dependent communications sessions. This is achieved by performing some of the connection set-up steps for delay-sensitive communications sessions after successfully demodulating a smaller number of indications identifying an access terminal's desired serving resource than would be demodulated in the case of a confidence-dependent communication session prior to performing the same connection set-up steps.
Abstract:
The present solution enables a packet switched connection to be temporarily released at the wireless terminal for supporting voice calls over a Circuit-Switched (CS) Fallback. The packet switched connection of the LTE core network retained for a pre-defined period of time during the CSFB session allowing the user to quickly switch back to the packet switched connection when the CSFB session is shorter than the predefined period or when the voice call CSFB attempt fails. This is accomplished by the introduction of a timed buffer to control the length of time the LTE core network connection and wireless context information will be retained.
Abstract:
This application provides an adaptive damping magnetic field sensor, including: a receiving coil, an adaptive damping matching resistance circuit, and an amplifying circuit; where the receiving coil is used for receiving an earth response signal generated by the earth under excitation of an emission source, and generating an induced voltage; the adaptive damping matching resistance circuit is used for receiving the induced voltage generated by the receiving coil and automatically matching a damping resistance value to obtain a near-source broadband observation signal; and the amplifying circuit is used for amplifying the observation signal with a constant gain and outputting a sensor output signal. This application carries out automatic matching control on the damping resistance value through the adaptive damping matching resistance circuit, thereby ensuring that the sensor can stably and reliably implement fine observation of an earth response under near-source, broadband and complex scene conditions.
Abstract:
A cellular wireless communication system includes base transceiver stations and mobile stations that operate with a closed loop power control. The mobile tracking is performed based on the lock in and lock out thresholds by the base transceiver stations. A forward link power control bit is decoded from the reverse channel. An additional threshold is introduced for determining at the base transceiver station whether the decoded forward link power control bit is valid or invalid. The finger energies obtained from a finger processor formed by a RAKE receiver of the base transceiver station are compared to the additional validation threshold. The additional validation threshold is independent of the tracking thresholds and usually greater than them. The validation performance may not be affected by low signal/noise. The forward link traffic channel gain of the base transceiver station is controlled in response to the invalidity of the decoded forward power control bit. The decoding of the reverse link power control bit and the validity determination of the decoded reverse link power control bit are performed by similar methods to those of the forward link power control bit. With improved validation methods, the forward link and reverse link transmission power is more accurately controlled.
Abstract:
A method of connection setup in mobile wireless data communications systems is disclosed where the connection setup time is decreased for delay-sensitive communications sessions relative to the normal connection setup time for confidence-dependent communications sessions. This is achieved by performing some of the connection set-up steps for delay-sensitive communications sessions after successfully demodulating a smaller number of indications identifying an access terminal's desired serving resource than would be demodulated in the case of a confidence-dependent communication session prior to performing the same connection set-up steps.
Abstract:
A method of connection setup in mobile wireless data communications systems is disclosed where the connection setup time is decreased for delay-sensitive communications sessions relative to the normal connection setup time for confidence-dependent communications sessions. This is achieved by performing some of the connection set-up steps for delay-sensitive communications sessions after successfully demodulating a smaller number of indications identifying an access terminal's desired serving resource than would be demodulated in the case of a confidence-dependent communication session prior to performing the same connection set-up steps.