摘要:
Disclosed is a distortion compensating apparatus for correcting the size of a distortion compensation coefficient in such a manner that a transmit signal that has undergone distortion compensation will not exceed the dynamic range of a DA converter. Specifically, before a distortion compensation coefficient hn+1(p) that has been calculated by a calculation unit is stored in a coefficient memory, an assumption is made that distortion compensation will be performed using the distortion compensation coefficient hn+1(p). Then it is determined beforehand whether a signal x(t)*hn+1(p) that will be obtained by this distortion compensation will exceed the limit of a DA converter. If the limit will be exceeded, the size of the distortion compensation coefficient is reduced by a correction unit, the corrected distortion compensation coefficient is stored in the memory and the transmit signal is corrected using the stored distortion compensation coefficient.
摘要翻译:公开了一种失真补偿装置,用于以经过失真补偿的发送信号不会超过DA转换器的动态范围的方式校正失真补偿系数的大小。 具体地说,在由计算单元计算出的失真补偿系数h N + 1(p)被存储在系数存储器中之前,假定将使用失真补偿执行失真补偿 系数h n + 1(p)。 然后,预先确定将通过该失真补偿获得的信号x(t)* h N + 1(p)将超过DA转换器的极限。 如果超过极限,则通过校正单元来减小失真补偿系数的大小,将校正的失真补偿系数存储在存储器中,并使用所存储的失真补偿系数校正发送信号。
摘要:
First, a digital section constituting a linearizer is activated. Then, a feedback loop for updating a distortion compensation coefficient is opened. Then, the analog section on the antenna side is activated from an ADC, including a PA, etc., or a DAC. Then, both the ATT value of an ATT installed in a feedback route for updating the distortion compensation coefficient and the signal delay amount of a signal delay unit are adjusted to make a state such that the distortion compensation coefficient can be accurately updated. Then, the feedback loop is closed, a distortion compensation table having the distortion compensation coefficient as an entry is generated and after the generation is completed, the operation shifts to the normal operation.
摘要:
In a distortion compensation device which uses distortion compensation coefficients to subject distortion compensation processing to an input signal and supply the result of the distortion compensation processing to a distorting device, calculates the distortion compensation coefficients based on the input signal before distortion compensation and the feedback signal fed back from the output side of the distorting device, and stores the calculated distortion compensation coefficients in association with the input signal, (1) the feedback signal is AD-converted; (2) the AD-converted output is subjected to fast Fourier transform (FFT) processing; (3) the FFT calculation result is used to calculate the value of either the signal-to-noise ratio SNR, or the adjacent channel leakage power ratio ACLR, or the noise level; (4) the delay time occurring in the distorting device and feedback loop is adjusted such that the difference between the above calculated value at the current time and the above calculated value at the immediately preceding time is either zero, or is equal to or less than a threshold value; and, (5) this adjustment processing is repeated to determine the accurate delay time, and based on this delay time the timing of each of the portions of the distortion compensation device is adjusted.
摘要:
A distortion compensating apparatus for correcting the size of a distortion compensation coefficient in such a manner that a transmit signal that has undergone distortion compensation will not exceed the dynamic range of a DA converter. Specifically, before a distortion compensation coefficient hn+1(p) that has been calculated by a calculation unit is stored in a coefficient memory, an assumption is made that distortion compensation will be performed using the distortion compensation coefficient hn+1(p). Then it is determined beforehand whether a signal x(t)*hn+1(p) that will be obtained by this distortion compensation will exceed the limit of a DA converter. If the limit will be exceeded, the size of the distortion compensation coefficient is reduced by a correction unit, the corrected distortion compensation coefficient is stored in the memory and the transmit signal is corrected using the stored distortion compensation coefficient.
摘要:
The present invention provides a transmission device for predistorting a digital signal in order to compensate distortion, then amplifying and transmitting it. A digital input signal is converted to a first analog signal by a first D/A converter. Separately, the digital input signal is also subjected to predistortion. A compensating signal is then generated from the digital input signal and the predistorted signal. The compensating signal generated thereby is converted into a second analog signal by a second D/A converter. The first analog signal and second analog signal are then added, this addition operation giving a compensated analog transmission signal. This analog transmission signal is supplied to the amplifier for amplification, and then transmitted via an antenna.
摘要:
Disclosed is a distortion compensating apparatus for correcting the size of a distortion compensation coefficient in such a manner that a transmit signal that has undergone distortion compensation will not exceed the dynamic range of a DA converter. Specifically, before a distortion compensation coefficient hn+1(p) that has been calculated by a calculation unit is stored in a coefficient memory, an assumption is made that distortion compensation will be performed using the distortion compensation coefficient hn+1(p). Then it is determined beforehand whether a signal x(t)*hn+1(p) that will be obtained by this distortion compensation will exceed the limit of a DA converter. If the limit will be exceeded, the size of the distortion compensation coefficient is reduced by a correction unit, the corrected distortion compensation coefficient is stored in the memory and the transmit signal is corrected using the stored distortion compensation coefficient.
摘要翻译:公开了一种失真补偿装置,用于以经过失真补偿的发送信号不会超过DA转换器的动态范围的方式校正失真补偿系数的大小。 具体地说,在由计算单元计算出的失真补偿系数h N + 1(p)被存储在系数存储器中之前,假定将使用失真补偿执行失真补偿 系数h n + 1(p)。 然后,预先确定将通过该失真补偿获得的信号x(t)* h N + 1(p)将超过DA转换器的极限。 如果超过极限,则通过校正单元来减小失真补偿系数的大小,将校正的失真补偿系数存储在存储器中,并使用所存储的失真补偿系数校正发送信号。
摘要:
A distortion compensation apparatus returns a part of an amplified output signal of a power amplifier amplifying a transmission signal, reads a distortion compensation signal from a distortion compensation table, multiplies the transmission signal with the distortion compensation signal thereof, and inputs the signal to the power amplifier. The distortion compensation signal corresponding to a signal calculated based on an error signal that is a difference between the transmission signal and the amplified output signal, the distortion compensation signal from the distortion compensation table and the step size parameter, and to a power of the transmission signal. The distortion compensation apparatus comprises a &mgr; control part including a fast Fourier transformation part that obtains a spectrum of the amplified output signal, a calculation part that calculates an adjacent channel leakage power ratio based on the spectrum, and a &mgr; adjusting part that varies the step size parameter by comparing the calculated adjacent leakage power ratio with a threshold value.
摘要:
Digital input signals xi and xq are multiplied by an multiplier 31 with a distortion compensation coefficient of a distortion compensation coefficient storage unit 33 and then processed by a modulation/amplification unit 1 for sending in the form of analog output signals Z. The analog output signals Z are fed back for processings by an attenuator 43, a mixer 41, a quadrature demodulator 39, etc., and then fed to subtractors 35i and 35q. The subtractors 35i and 35q find differences (errors) between analog input signals Xi and Xq and analog feedback signals Yi and Yq, respectively, and feeds the analog error signals to ADCs 36i and 36q, respectively. The ADCs 36i and 36q convert the analog error signals into digital signals and feeds the digital signals to a distortion compensation coefficient arithmetic unit 5. The distortion compensation coefficient arithmetic unit 5 figures out a new distortion compensation coefficient to update the distortion compensation coefficient storage unit 33.
摘要:
Distortion compensation coefficients for correcting distortion of a transmission power amplifier are stored in a memory beforehand, a distortion compensation coefficient conforming to powers or amplitudes of a present transmit signal and a past transmit signal is read out of the memory, and distortion compensation processing is applied to the transmit signal using this distortion compensation coefficient. The transmit signal thus subjected to distortion compensation processing is then amplified by the transmission power amplifier and the amplified signal is transmitted, and the distortion compensation coefficient is updated based upon the transmit signal before distortion compensation and an output signal from the transmission power amplifier.
摘要:
In a radio apparatus which compensates for non-linear distortion of a transmission power amplifier, a distributor feeds back the output signal of the transmission power amplifier, an error-signal estimating arithmetic unit digitally estimates an error signal, which is ascribable to non-linear distortion of the power amplifier, using a transmit signal and feedback signal, the transmit signal and the error signal are DA-converted by separate DA converters, and a combiner combines the output signals of the DA converters and inputs the combined signal to the transmission power amplifier to perform distortion compensation.