摘要:
Water is stored in a metal can, and water vapor is supplied to a separator through an opening in a washer. The separator is an alkali metal salt in a sulfonated synthetic resin membrane, and KOH aqueous solution is used as the electrolyte, and the sensing electrode and the counter electrode are Pt—C, and solid proton conductive membranes are placed between the electrodes and the separator.
摘要:
An output of a direct current power supply is divided with a pair of resistors, and applied to any of electrodes of an electrochemical gas sensor provided with a detection electrode, a counter electrode and a solid electrolyte membrane through a buffer amplifier. Impedance of the gas sensor is measured by switching with a switch the connection destination of one electrode of the electrochemical gas sensor between a current amplification circuit and an impedance measurement circuit. The impedance measurement circuit is formed of an alternating current power supply that switches a potential of a resistor on a side of one end connected to the switch and a potential on a side of the other end of the resistor, between the output potential and the ground potential of the direct current power supply. Gas concentration is determined by storing humidity dependency and temperature dependency of the electrochemical gas sensor, and correcting the output of the current amplification circuit based on measured impedance and ambient temperature.
摘要:
An aqueous solution of a Na salt of a phenol sulfonic acid polymer as a liquid electrolyte is held in a separator of a liquid electrochemical gas sensor. A sensing electrode and a counter electrode are connected to the separator to detect CO at a range from about −40° C. to about 70° C.
摘要:
A test signal is applied in parallel with an electrochemical gas sensor for about ten seconds, while an amplifying circuit is turned off. After turning off the test signal, the amplifying circuit is turned on. If the gas sensor outputs an waveform of a predetermined shape in a predetermined period after the turning-on, the gas sensor will be judged to be normal.
摘要:
A test signal is applied in parallel with an electrochemical gas sensor for about ten seconds, while an amplifying circuit is turned off. After turning off the test signal, the amplifying circuit is turned on. If the gas sensor outputs an waveform of a predetermined shape in a predetermined period after the turning-on, the gas sensor will be judged to be normal.
摘要:
Water is stored in a metal can, and water vapor is supplied to a separator through an opening in a washer. The separator is an alkali metal salt in a sulfonated synthetic resin membrane, and KOH aqueous solution is used as the electrolyte, and the sensing electrode and the counter electrode are Pt-C, and solid proton conductive membranes are placed between the electrodes and the separator.
摘要:
An insulating glass film is formed on a heater film, and a gas sensitive film is formed on the glass film. The MgO content in the glass is kept at 0.1 wt % or under to prevent Mg from eluting into absorbed water at low temperatures and segregating on the cathode by the detection voltage.