摘要:
A DC-DC converter for outputting dc voltage whose peak value is higher than an input dc voltage value and high-frequency voltage corresponding to a command value is superimposed. An insulated switching power supply 27 and a series regulator 26 are connected in parallel to a dc power supply 1. The insulated switching power supply 27 generates output voltage V.sub.2 having a certain level, and the series regulator 26, output voltage V.sub.1 whose voltage varies depending on a command value (command voltage varying at a high frequency). Then, the sum of the output voltages V.sub.1 and V.sub.2 is fed to the load 9.
摘要:
There is obtained an ignition apparatus, for an internal combustion engine, that can make a predetermined output current flow in a stable manner so that the combustion state of the internal combustion engine can always be maintained in a good condition, even in the case where the voltage of the power source connected with the energy storing coil fluctuates. There are provided an energy storing coil (3), a switching means (S1) for accumulating energy, an ignition coil (4), and a switching means (S2) that turns on/off an ignition current; the switching means (S1) and (S2) are alternately turned on/off so that a current with a alternating polarity is made to flow continuously in the ignition coil (6); a switching means (S3) is connected both terminals of the energy storing coil (3); and when a current flowing in the energy storing coil (3) reaches a target value, the switching means (S1) is turned off and the switching means (S3) is turned off so that the energy storing coil current circulates through the switching means (S3) so as to keep the current to be approximately the target value.
摘要:
There is obtained an ignition apparatus, for an internal combustion engine, that can make a predetermined output current flow in a stable manner so that the combustion state of the internal combustion engine can always be maintained in a good condition, even in the case where the voltage of the power source connected with the energy storing coil fluctuates. There are provided an energy storing coil (3), a switching means (S1) for accumulating energy, an ignition coil (4), and a switching means (S2) that turns on/off an ignition current; the switching means (S1) and (S2) are alternately turned on/off so that a current with a alternating polarity is made to flow continuously in the ignition coil (6); a switching means (S3) is connected both terminals of the energy storing coil (3); and when a current flowing in the energy storing coil (3) reaches a target value, the switching means (S1) is turned off and the switching means (S3) is turned off so that the energy storing coil current circulates through the switching means (S3) so as to keep the current to be approximately the target value.
摘要:
To reduce a total power amount required to drive an elevator by a commercial power supply during a peak power-consumption time period, for instance, afternoon in summer time, a control apparatus for this elevator is arranged by employing: a converter for rectifying AC electric power to be converted into DC electric power; and inverter for inverting the DC electric power into AC electric power having a variable voltage and a variable frequency; a motor driven by said AC electric power having the variable voltage and the variable frequency so as to operate an elevator; a power storage apparatus for charging thereinto electric power; and a power controller for using both the power storage apparatus and the commercial power supply so as to supply the electric power to the inverter, and for controlling at least any one of the power storage apparatus and the commercial power supply in order to supply electric power which is required for the inverter.
摘要:
An elevator control apparatus includes a power storage unit for storing the DC power; a charge/discharge control circuit that controls a state of charge of the power storage unit, outputs a drive signal to charge the power storage unit with the DC power during a halt of the elevator based on operational information regarding the elevator received from the controller, and outputs a stop signal to stop charging when a voltage of the power storage unit reaches a preset voltage; and a charge/discharge circuit for starting charging the power storage unit with the DC power in response to the drive signal, and stopping the charging in response to the stop signal. This arrangement ensures landing of the elevator in case of a power failure, eliminates a peak in power consumption, and permits energy saving by effectively using power produced in a regenerative mode of the elevator.
摘要:
An elevator control device includes: a convertor which rectifies a.c. power and converts the a.c. power into d.c. power; an inverter which converts the d.c. power into a.c. power having a variable voltage and a variable frequency; an electric motor which is driven by the a. c. power having a variable voltage and a variable frequency to operate an elevator; a power storing unit which is charged with electric power; a required-power arithmetically operating circuit which calculates power required by the elevator, which is an electric power required for the operation of the elevator or an electric power caused by the operation of the elevator; and a charging/discharging control circuit which controls charging and discharging of the power storing unit based on the power required by the elevator.
摘要:
Provided is an electric double layer capacitor including a large capacity single cell having a large electrostatic capacity and a small capacity single cell are connected to the same exterior case in parallel, and a thickness of a separator of the large capacity single cell is made thicker than a thickness of a separator of the small capacity single cell. With this structure, a supply amount of an electrolyte solution to the large capacity single cell is markedly increased compared with the small capacity single cell, thereby being capable of preventing degradation of the large capacity single cells and the small capacity single cells and providing the electric double layer capacitor having an excellent cycle life and having a large power storage amount while keeping characteristics capable of instantaneously allowing large current to flow.
摘要:
A power supply apparatus for controlling an ion accelerator includes a controller configured to adjust magnitude of ion acceleration in the ion accelerator. The controller controls an anode voltage applied to an anode electrode of the ion accelerator, a gas flow rate of gas flowing through a gas flow rate regulator of the ion accelerator, and magnetic flux density at an ion exit of the ion accelerator to satisfy a formula given as follows: 500 × 10 9
摘要:
An elevator control apparatus includes a converter; an inverter; a controller for controlling a motor based on the AC power having a variable voltage and a variable frequency supplied from the inverter and operating an elevator; a power storage unit for storing the DC power; a thermistor for detecting temperature of the power storage unit; a charge/discharge control circuit for controlling a charging and discharging of the power storage unit based on the detected temperature and issuing a drive signal; and a charge/discharge circuit for charging and discharging the power storage unit based on the drive signal. The elevator control apparatus estimates a charging and discharging capability of the power storage unit and protecting the power storage unit, restraining sudden deterioration of the power storage unit.
摘要:
An elevator controller for stably controlling charging and discharging of a power accumulating device by using a cheap secondary battery having a low capacity, without damaging energy saving effects obtained by charging. The controller of the elevator includes a converter for rectifying AC power and converting the AC power to DC power; an inverter for converting the DC power to AC power having a variable voltage and a variable frequency to operate the elevator; a power accumulating device for accumulating DC power from a DC bus in a regenerative operation and supplying the DC power in a power operation; a charging-discharging control circuit for controlling charging and discharging operations of the power accumulating device; a series connecting body, arranged between DC buses, and a gate for regenerative current control and a regenerative resistor; a regenerative control circuit for controlling operation of the gate for regenerative current control; and a charging discharging state measuring device measuring charging and discharging state of the power accumulating device.