Abstract:
In general, the disclosure describes techniques for communicating multicast group leave requests between two or more load-balanced, multi-homed PE routers included in an Ethernet Virtual Private Network (EVPN). The techniques of the disclosure enable the two or more PE routers to synchronize IGMP state and routing information amongst one another to ensure that the one of the multi-homed PE routers elected as the designated forwarder (DF) ceases forwarding the multicast group traffic to the CE router, even if it is not the PE router that receives the IGMP leave request.
Abstract:
In general, techniques of this disclosure may enable a remote provider edge (PE) router to improve convergence time in response to a link failure in an Ethernet Virtual Private Network (EVPN) by establishing per-Ethernet Segment Identifier (ESI) Bidirectional Forwarding Detection (BFD) sessions with other PE routers that are coupled to the PE router in an EVPN. The remote PE may determine that at least two PE routers with the remote PE are locally connected to a multi-homed customer network by a particular Ethernet Segment. The remote PE may send, based on determining that the at least two PE routers are connected to the multi-homed customer network by the particular Ethernet Segment, an ESI Ping request packet through the intermediate network to one of the at least two PE routers, wherein the ESI Ping request packet includes at least a BFD discriminator and an ESI for the particular Ethernet Segment.
Abstract:
In general, techniques enable an intermediate router to perform node protection for one or more other PE routers operably coupled to the intermediate router in active-active mode in an EVPN. The techniques may include configuring the intermediate router, which is positioned within an a service provider network between a remote provide edge router and at least two provider edge (PE) routers operating in active-active mode in an Ethernet Virtual Private Network (EVPN), to operate in a passive mode in which the intermediate router detects Ethernet Auto-Discovery (AD) routes without performing layer two (L2) address learning for the EVPN. The techniques may include installing a primary route to a protected router and a backup route from the intermediate router to a PE router other than the protected router, and in response to a link failure, forwarding network traffic using the backup route without requiring reprogramming the forwarding unit.
Abstract:
In some examples, a method includes receiving, by a first provider edge (PE) network device, an egress protection label that is advertised by a second PE network device, wherein each of the first and second PE network devices are included in an Ethernet segment, wherein the first PE network device is a designated forwarder for BUM network packets in the Ethernet segment, and wherein a CE network device is multi-homed to the first and second PE network devices; in response to detecting a link failure, configuring forwarding information of the first PE network device to apply the egress protection label to the BUM network packets received by the first PE network device and forward the BUM network packets to the second PE network device; and in response to receiving the BUM network packets, forwarding the BUM network packets with the egress protection label to the second PE network device.
Abstract:
Techniques are described for facilitating node protection for Broadcast, unknown Unicast, and Multicast (BUM) traffic for a multi-homed node failure. For example, each VTEP (e.g., PE device) may advertise a protected VTEP address that indicates an IP address of a remote PE device that is to be protected in the event of a node failure. In the event a multi-homed PE device fails, the ingress PE device sends a BUM packet including the protected VTEP address for the failed node. When an egress PE device receives the BUM packet, the egress PE device determines whether the BUM packet includes the protected VTEP address and whether the egress PE device is operating as a backup designated forwarder (DF). If the BUM packet includes the protected VTEP address and the egress PE device is a backup DF, the egress PE device forwards the BUM traffic to the ESI.
Abstract:
Techniques are disclosed for an Ethernet Virtual Private Network (EVPN) Virtual Private Wire Service (VPWS) network with service interface-aware forwarding. In one example, a first network device signals to a second network device, using EVPN route advertisements, a multi-service service tunnel to transport network packets for a plurality of services. The services are identifiable by virtual local area network (VLAN) identifiers in the packets. The first network device is configured with a single transport interface for the service tunnel and the single transport interface is configured with respective service interfaces for the services. The first network device detects failure of a failed service interface of the service interfaces and outputs, in response to the failure, an EVPN route withdrawal message for the service tunnel that identifies the service corresponding to the failed service interface.
Abstract:
Techniques are disclosed for an Ethernet Virtual Private Network (EVPN) Virtual Private Wire Service (VPWS) network with service interface-aware forwarding. In one example, a first network device signals to a second network device, using EVPN route advertisements, a multi-service service tunnel to transport network packets for a plurality of services. The services are identifiable by virtual local area network (VLAN) identifiers in the packets. The first network device is configured with a single transport interface for the service tunnel and the single transport interface is configured with respective service interfaces for the services. The first network device detects failure of a failed service interface of the service interfaces and outputs, in response to the failure, an EVPN route withdrawal message for the service tunnel that identifies the service corresponding to the failed service interface.
Abstract:
In general, the disclosure describes techniques for communicating multicast group leave requests between two or more load-balanced, multi-homed PE routers included in an Ethernet Virtual Private Network (EVPN). The techniques of the disclosure enable the two or more PE routers to synchronize IGMP state and routing information amongst one another to ensure that the one of the multi-homed PE routers elected as the designated forwarder (DF) ceases forwarding the multicast group traffic to the CE router, even if it is not the PE router that receives the IGMP leave request.
Abstract:
In general, techniques are described for load-balancing responsibility for forwarding of multicast traffic into an active-active Ethernet segment between two or more multi-homed provider edge (PE) routers in an Ethernet Virtual Private Network (EVPN). In one example, a PE router may receive an Internet Group Management Protocol (IGMP) join report for a multicast group. The PE router may send join synch routes used to synchronize the join report for the multicast group across the Ethernet segment. The PE router may deterministically determine whether the PE router is configured to be an elected multicast forwarder for one of a plurality of multicast groups. If the PE router is elected a multicast forwarder, the PE router may configure a forwarding state of the PE router to ignore a designated forwarder calculation and to forward the multicast traffic into the Ethernet segment regardless of whether the PE router is a designated forwarder.
Abstract:
Techniques are disclosed for handling withdrawals of Border Gateway Protocol (BGP) join synch routes used to synchronize multicast group join requests. In one example, a first provider edge (PE) router of a plurality of PE routers on an Ethernet segment of an Ethernet Virtual Private Network (EVPN) receives, from a second PE router, a withdrawal of a BGP join synch route. In response, the first PE router determines whether a disruption event or a multicast state timeout event at the second PE router caused the withdrawal. If the disruption event caused the withdrawal, the first PE router retains a multicast state for the multicast group and forwards multicast traffic for the multicast group to a customer edge (CE) router multi-homed to the plurality of the PE routers. If the multicast state timeout event caused the withdrawal, the first PE router deletes the multicast state and stops forwarding the multicast traffic.