Engine ignition shutdown module
    1.
    发明授权
    Engine ignition shutdown module 有权
    发动机点火关机模块

    公开(公告)号:US09556846B2

    公开(公告)日:2017-01-31

    申请号:US13793692

    申请日:2013-03-11

    申请人: Deere & Company

    IPC分类号: F02P11/02

    CPC分类号: F02P11/025

    摘要: An engine ignition shutdown module includes a voltage regulator circuit connected to a key switch, and a pair of isolated MOSFET driver circuits connected to the voltage regulator circuit. Each MOSFET driver circuit charges a capacitor while the key switch is in a run position and the interlock switches are closed, and each capacitor discharges through a resistor for a time delay period once the key switch is moved from the run position to an off position or at least one of the interlock switches are opened. A pair of high voltage output MOSFET transistors are switched on while the capacitors discharge and provide an output to a magneto ignition for the time delay period.

    摘要翻译: 发动机点火关闭模块包括连接到钥匙开关的电压调节器电路和连接到电压调节器电路的一对隔离MOSFET驱动器电路。 当钥匙开关处于运行位置并且互锁开关闭合时,每个MOSFET驱动器电路对电容器充电,并且一旦钥匙开关从运行位置移动到关闭位置,每个电容器通过电阻器放电一段时间延迟时段,或者 互锁开关中的至少一个被打开。 一对高压输出MOSFET晶体管导通,同时电容器放电并在时间延迟期间向磁点火提供输出。

    End of cut speed control system
    2.
    发明授权
    End of cut speed control system 有权
    切割速度控制系统结束

    公开(公告)号:US09179596B2

    公开(公告)日:2015-11-10

    申请号:US13891344

    申请日:2013-05-10

    申请人: Deere & Company

    CPC分类号: A01D34/006 B60T8/1755

    摘要: An end of cut speed control system includes a vehicle controller that commands a traction drive system to a reduced ground speed based on the setting of a control to a preset end of cut mode ground speed as a percentage of the mow mode ground speed. The vehicle controller changes the speed from the mow mode to the end of cut mode when a proximity sensor indicates the cutting units are raised to a cross cut position.

    摘要翻译: 切割速度控制系统的结束包括车辆控制器,其基于将切割模式地面速度的预设末端的设置设置为剪切模式地面速度的百分比来命令牵引驱动系统降低地面速度。 当接近传感器指示切割单元升高到十字切换位置时,​​车辆控制器将速度从剪切模式改变到剪切模式结束。

    Mower hydraulic leak detection system

    公开(公告)号:US11606898B2

    公开(公告)日:2023-03-21

    申请号:US16802406

    申请日:2020-02-26

    申请人: DEERE & COMPANY

    摘要: A hydraulic leak detection system includes a leak detection switch responsive to a level of hydraulic fluid in a tank used by a hydraulic mowing circuit and a lift and lower circuit of a grass mowing machine. The system includes a controller that activates a warning indicator if the leak detection switch indicates the level of hydraulic fluid in the tank is low, but allows the hydraulic mowing circuit and the lift and lower circuit to continue operating until the lift and lower circuit reaches a fully raised position. A solenoid valve may control the level of hydraulic fluid in the tank based on temperature of the hydraulic fluid.

    END OF CUT SPEED CONTROL SYSTEM
    5.
    发明申请
    END OF CUT SPEED CONTROL SYSTEM 有权
    切割速度控制系统结束

    公开(公告)号:US20140331630A1

    公开(公告)日:2014-11-13

    申请号:US13891344

    申请日:2013-05-10

    申请人: Deere & Company

    IPC分类号: A01D34/00

    CPC分类号: A01D34/006 B60T8/1755

    摘要: An end of cut speed control system includes a vehicle controller that commands a traction drive system to a reduced ground speed based on the setting of a control to a preset end of cut mode ground speed as a percentage of the mow mode ground speed. The vehicle controller changes the speed from the mow mode to the end of cut mode when a proximity sensor indicates the cutting units are raised to a cross cut position.

    摘要翻译: 切割速度控制系统的结束包括车辆控制器,其基于将切割模式地面速度的预设末端的设置设置为剪切模式地面速度的百分比来命令牵引驱动系统降低地面速度。 当接近传感器指示切割单元升高到十字切换位置时,​​车辆控制器将速度从剪切模式改变到剪切模式结束。

    ENGINE IGNITION SHUTDOWN MODULE
    6.
    发明申请
    ENGINE IGNITION SHUTDOWN MODULE 有权
    发动机点火开关模块

    公开(公告)号:US20140251271A1

    公开(公告)日:2014-09-11

    申请号:US13793692

    申请日:2013-03-11

    申请人: DEERE & COMPANY

    IPC分类号: F02P9/00

    CPC分类号: F02P11/025

    摘要: An engine ignition shutdown module includes a voltage regulator circuit connected to a key switch, and a pair of isolated MOSFET driver circuits connected to the voltage regulator circuit. Each MOSFET driver circuit charges a capacitor while the key switch is in a run position and the interlock switches are closed, and each capacitor discharges through a resistor for a time delay period once the key switch is moved from the run position to an off position or at least one of the interlock switches are opened. A pair of high voltage output MOSFET transistors are switched on while the capacitors discharge and provide an output to a magneto ignition for the time delay period.

    摘要翻译: 发动机点火关闭模块包括连接到钥匙开关的电压调节器电路和连接到电压调节器电路的一对隔离MOSFET驱动器电路。 当钥匙开关处于运行位置并且互锁开关闭合时,每个MOSFET驱动器电路对电容器充电,并且一旦钥匙开关从运行位置移动到关闭位置,每个电容器通过电阻器放电一段时间延迟时段,或者 互锁开关中的至少一个被打开。 一对高压输出MOSFET晶体管导通,同时电容器放电并在时间延迟期间向磁点火提供输出。