摘要:
A code information reading section selects recording codes which are respectively recorded on a plurality of recording media one at a time, and sequentially optically reads the recording codes in order to make it possible to synthesize a plurality of audio information items which are previously coded and recorded in an optically readable form and to simultaneously output them. A code information decoding section sequentially decodes the recording codes read by the code information reading section. A decoded information synthesizing section sequentially synthesizes digital audio signals sequentially decoded by the code information decoding section. A D/A converter converts the digital audio signal synthesized by the decoded information synthesizing section into an analog audio signal. An audio output section outputs the analog audio signal converted by the D/A converter as an audio output.
摘要翻译:代码信息读取部分一次选择分别记录在多个记录介质上的记录代码,并且顺序地光学读取记录代码,以使得可以合成预先编码和记录的多个音频信息项 以光学可读形式并同时输出它们。 代码信息解码部分对由代码信息读取部分读取的记录代码进行顺序解码。 解码信息合成部分顺序地合成由码信息解码部分顺序解码的数字音频信号。 D / A转换器将由解码信息合成部分合成的数字音频信号转换为模拟音频信号。 音频输出部分输出由D / A转换器转换的模拟音频信号作为音频输出。
摘要:
A reconstituting section obtains block-address information from each of read out blocks. According to the obtained pattern in the block-address information obtained by the reconstituting section, a reproducing section determines a code-scanning state of manual scanning performed along a scanning direction. When scanning is performed in an off-code state and an overspeed state, and when scanning is terminated in an incomplete state, notification is performed in each of modes differing from each other depending on the scanning state.
摘要:
A battery system includes a battery module that is constituted with a plurality of serially connected battery cells, a plurality of integrated circuits that group the battery cells so as to perform processing on battery cells in each group, a first transmission path through which a command signal is transmitted via a first insulating circuit from a higher-order control circuit that controls the integrated circuits to a highest-order integrated circuit of the integrated circuit, a second transmission path through which a data signal collected by the integrated circuits is transmitted from the highest-order integrated circuit to a lowest-order integrated circuit, and a third transmission path through which the data signal is transmitted from the lowest-order integrated circuit to the higher-order control circuit via a second insulating circuit.
摘要:
A battery monitoring device for monitoring a cell group made by connecting a plurality of single battery cells in series includes a reference voltage generation circuit configured to generate a variable reference voltage, a switching circuit configured to select, as a measurement target voltage, any one of a plurality of types of voltages including the cell voltages of the single battery cells in the cell group and the reference voltage, and an AD converter configured to measure the measurement target voltage which is selected by the switching circuit, and output a digital signal according to the measurement result.
摘要:
A battery system monitoring apparatus that monitors a battery system is provided having a cell group having a plurality of unit cells connected in series, including: a first control device that controls the cell group; and a plurality of voltage detection lines that connect positive electrodes and negative electrodes of the unit cells to the first control device, for measuring inter-terminal voltages of the unit cells. The first control device includes a balancing switch connected between the voltage detection line connected to the positive electrode of each unit cell and the voltage detection line connected to the negative electrode thereof for conducting balancing discharge of the unit cell, for each of the unit cells. A first resistor is disposed in series with each of the voltage detection lines, a first capacitor is connected between the voltage detection line, and a GND which is a lowest-level potential of the cell group.
摘要:
A suppressed noise cell controller includes, corresponding to a number of cell packs, a plurality of ICs each having a voltage detecting circuit detecting voltages of respective cells of a cell pack in which four cells are connected in series, a switch control circuit controlling conduction and a blocking operation of a plurality of switch elements connected in parallel to the respective cells via capacity adjusting resistors, terminal LIN1 for inputting control information, terminal LIN2 for outputting control information, terminal Vcc and GND terminal, and terminal LIN2 of a higher-order IC and terminal LIN1 of a lower-order IC are daisy chain connected. The Vcc terminal of each IC is connected to a positive electrode of a higher-order cell among cells constituting a corresponding cell pack via a noise eliminating inductor, and the GND terminal is coupled directly to Vcc of the lower-order IC. Noise isn't superposed on LIN1 or LIN2.
摘要:
A battery monitoring device for monitoring a cell group made by connecting a plurality of single battery cells in series including a first switching circuit configured to select, as a measurement target voltage, a type of voltage a differential amplifier circuit including a first input terminal and a second input terminal, configured to convert the measurement target voltage, which is selected by the first switching circuit and input between the first input terminal and the second input terminal, into a voltage in a predetermined range by performing differential amplification, and an AD converter configured to measure the measurement target voltage selected by the first switching circuit and converted by the differential amplifier circuit, and output a digital signal according to the measurement result, wherein an abnormality detection voltage, is output to the AD converter.
摘要:
A battery monitoring system includes a plurality of battery monitoring devices connected to a battery formed by connecting a plurality of battery cell groups in series, and monitor a state of the battery for the respective battery cell groups, each of the plurality of battery cell groups being of one or a plurality of battery cells connected in series, and a controller that performs wireless communication with the plurality of battery monitoring devices. First identification information portions which are different from each other are set in the plurality of battery monitoring devices in advance, and second identification information corresponding to an order of potentials of the battery cell groups in the battery, to which the battery monitoring devices are connected, is assigned to each of the plurality of battery monitoring devices. The controller stores a relationship between the first and second identification information for each battery monitoring device.
摘要:
A battery control device for a battery module includes a plurality of integrated circuits. Each integrated circuit includes: a constant voltage circuit that lowers a total voltage of a battery cell group corresponding to the integrated circuit to an integrated circuit internal voltage; a signal generation circuit that generates, based upon a first signal provided by a higher-order control circuit, a second signal assuming a wave height value different from a wave height value of the first signal and outputs the second signal; and a startup circuit that includes a first comparator assuming a first decision-making threshold value corresponding to the first signal and a second comparator assuming a second decision-making threshold value corresponding to the second signal, and starts up the constant voltage circuit in response to a change in an output from at least either the first comparator or the second comparator.
摘要:
A cell controller with excellent reliability in which noise and soon are suppressed is provided. The cell controller includes, corresponding to the number of cell packs, a plurality of ICs each having a voltage detecting circuit detecting voltages of respective cells of a cell pack in which four cells are connected in series, a switch control circuit controlling conduction and a blocking operation of a plurality of switch elements connected in parallel to the respective cells via capacity adjusting resistors, a LIN1 terminal for inputting control information, a LIN2 terminal for outputting control information, a Vcc terminal and a GND terminal, and a LIN2 terminal of a higher-order IC and a LIN1 terminal of a lower-order IC are connected in a daisy chain. The Vcc terminal of each IC is connected to a positive electrode of a higher-order cell among cells constituting a corresponding cell pack via an inductor L for eliminating noise, and the GND terminal is coupled directly to the Vcc terminal of the lower-order IC. Noise is not superposed on the LIN1, LIN2 terminals.