摘要:
Techniques for transmitting data with short-term interference mitigation in a wireless communication system are described. In one design, a first station (e.g., a base station or a terminal) may receive a message sent by a second station to request reduction of interference on at least one resource. In response to receiving the message, the first station may determine a first transmit power level to use for the at least one resource based on one or more factors such as a priority metric sent in the message, the buffer size at the first station, etc. The first station may send a power decision pilot on the at least one resource at a second transmit power level determined based on the first transmit power level.
摘要:
Techniques for managing peak-to-average power ratio (PAPR) for multi-carrier modulation in wireless communication systems. Different terminals in a multiple-access system may have different required transmit powers. The number of carriers to allocate to each terminal is made dependent on its required transmit power. Terminals with higher required transmit powers may be allocated fewer carriers (associated with smaller PAPR) to allow the power amplifier to operate at higher power levels. Terminals with lower required transmit powers may be allocated more carriers (associated with higher PAPR) since the power amplifier is operated at lower power levels. The specific carriers to assign to the terminals may also be determined by their transmit power levels to reduce out-of-band emissions. Terminals with higher required transmit powers may be assigned with carriers near the middle of the operating band, and terminals with lower required transmit powers may be assigned with carriers near the band edges.
摘要:
Systems and methodologies are described that facilitate employing interference-overload indications to generate pilot strength reports that can be leveraged to mitigate reverse link interference. An affected base station can send interference-overload indications when experiencing a strong interference/jamming scenario due to reverse link transmission by an offending access terminal. The offending access terminal can monitor interference-overload indications from the affected base station (e.g., although the affected base station can be excluded from an active set of the offending access terminal) and send a pilot strength report to a serving base station in response. The serving base station can receive the interference induced pilot strength report and command the offending access terminal not to transmit on certain channel resources (e.g., time, frequency, spatial, . . . ); thus, the affected base station can use these resources to schedule transmission(s) by access terminal(s) served thereby.
摘要:
To support mobile stations that are not capable of demodulating the entire bandwidth or that can be made to demodulate less than the entire bandwidth, a system, apparatus and method are provided to schedule users on less than all of the bandwidth. Further, certain users can be scheduled on more of the bandwidth than others.
摘要:
Techniques for transmitting null pilots to support interference estimation in a wireless network are described. A null pilot is non-transmission on designated time-frequency resources by a cell or a cluster of cells supporting cooperative transmission to a UE. The received power of the null pilot from the cell or cluster of cells may be indicative of interference from other cells. In one design, a cell in the cluster may determine resources for sending a null pilot by the cell. The cell may transmit the null pilot (i.e., send no transmissions) on the resources to allow UEs to estimate out-of-cluster interference. Some or all cells in the cluster may transmit null pilots on the same resources. The cell may receive interference and channel information from the UE and may send data transmission to the UE based on the interference and/or channel information. Remaining cells in the cluster may reduce interference to the UE.
摘要:
Techniques for adjusting transmit power to mitigate both intra-sector interference to a serving base station and inter-sector interference to neighbor base stations are described. The amount of inter-sector interference that a terminal may cause may be roughly estimated based on the total interference observed by each neighbor base station, channel gains for the serving and neighbor base stations, and the current transmit power level. The transmit power may be decreased if high interference is observed by a neighbor base station and increased otherwise. The transmit power may be adjusted by a larger amount and/or more frequently if the terminal is located closer to the neighbor base station observing high interference and/or if the current transmit power level is higher, and vice versa. The intra-sector interference is maintained within an acceptable level by limiting a received SNR for the terminal to be within a range of allowable SNRs.
摘要:
Systems and methodologies are described that facilitate scheduling over multiple hops in a wireless communication network. Radio resources can be partitioned into sets of sub-frames that can be allocated statically and/or dynamically. Statically allocated radio resources can be reassigned over time based on the loading on each hop and/or throughput imbalance. In addition, dynamic assignment of sub-frames to each hop can be based on traffic or channel conditions. Moreover, the radio resources can be dynamically allocated in a distributed scheme, wherein a base station controls the scheduling of resources, or a centralized scheme, wherein a relay station controls the scheduling of resources. Furthermore the allocation of radio resources can be transparent or explicit. In the transparent case, the access terminal listens directly to the base station, and the relay station does not transmit control information, such as DL or UL assignments. Conversely, when the allocation of resources is explicit the relay station does transmit control information.
摘要:
Techniques for mitigating interference on control channels in a wireless communication network are described. In an aspect, high interference on radio resources used for a control channel may be mitigated by sending a request to reduce interference to one or more interfering stations. Each interfering station may reduce its transmit power on the radio resources, which may then allow the control channel to observe less interference. In one design, a user equipment (UE) may detect high interference on radio resources used for a control channel by a desired base station. The UE may send a request to reduce interference on the radio resources to an interfering base station, which may reduce its transmit power on the radio resources. The UE may receive the control channel on the radio resources from the desired base station and may observe less interference from the interfering base station.
摘要:
Calibration for a transmit chain of a device transmitting information to multiple devices over wireless links and receive chains of the multiple devices receiving information over one of the wireless links utilizing a plurality of forward link channel estimates received from at least some of the plurality of devices and a plurality of reverse link channel estimates from the plurality of devices.
摘要:
For restrictive reuse, each cell (or each sector) is assigned (1) a set of usable subbands that may be allocated to users in the cell and (2) a set of forbidden subbands that is not used. The usable and forbidden sets for each cell are orthogonal to one other. The usable set for each cell also overlaps the forbidden set for each neighboring cell. A user u in a cell x may be allocated subbands in the usable set for that cell. If user u observes/causes high level of interference from/to a neighboring cell y, then user u may be allocated subbands from a “restricted” set containing subbands included in both the usable set for cell x and the forbidden set for cell y. User u would then observe/cause no interference from/to cell y. The subband restriction may be extended to avoid interference from multiple neighboring cells.