Abstract:
A direct-current power supply device is a direct-current power supply device that converts a three-phase alternating current to a direct current and supplies the direct current to a load, and includes a first capacitor and a second capacitor connected in series between output terminals to the load, a charge unit that selectively charges one or both of the first capacitor and the second capacitor, and a control unit that controls the charge unit. The control unit controls an output voltage of the direct-current power supply device by a charging period of the charge unit, and also controls a power factor and a harmonic current of the direct-current power supply device by a charge timing with respect to a reference phase of the three-phase alternating current of the charge unit as a reference.
Abstract:
The DC power-supply device includes a rectifier circuit rectifying an alternating current, a reactor connected to an input or output side of the rectifier circuit, a first capacitor and a second capacitor serially connected between output terminals to a load, and a charging unit that selectively charges one or both of the first capacitor and the second capacitor. A ratio, to a period obtained by combining a charging period and a non-charging period of a pair of the first capacitor and the second capacitor, of the non-charging period, is controlled according to an operating condition of the load, to change a charging frequency of the first capacitor and the second capacitor based on the ratio, at the time of controlling an output voltage to the load.
Abstract:
A heat pump device capable of efficiently and reliably preventing a liquid refrigerant from stagnating in a compressor an air conditioner, a heat pump water heater, a refrigerator, and a freezing machine including the heat pump device. The configuration is such that, when the compressor is under operation standby, a high-frequency voltage synchronizing with a carrier signal is supplied to the compressor motor to carry out the locked energization of the compressor motor. From respective inter-phase voltages, respective phase voltages, or respective phase currents of the compressor motor for a plurality of high-frequency energization cycles, the detection values for one high-frequency energization cycle are restored. A power value calculated using the restored detection values for one high-frequency energization cycle is controlled to coincide with a heating power command necessary for discharging the liquid refrigerant stagnated in the compressor to the outside of the compressor.
Abstract:
A heat pump apparatus includes: an inverter that applies a high-frequency voltage to a motor that drives a compressor, the high-frequency voltage having a frequency higher than or equal to an operation frequency of the compressor; and an inverter controller that switches between positive and negative directions of an output voltage output from the inverter every half period of a carrier signal, the carrier signal being used for generating a switching signal, the switching signal controlling whether each of the switching elements is on or off. The inverter controller prohibits switching between positive and negative directions of the output voltage in a first time period, the first time period being a time period of an integer multiple of two or more times the half period of the carrier signal.
Abstract:
A power converter including: a non-boost rectifier circuit that converts a first alternating-current voltage into a direct-current voltage; a reactor connected to the rectifier circuit; a capacitor that smooths a direct-current voltage; an inverter that is connected in parallel to the capacitor, converts the smoothed direct-current voltage into a second alternating-current voltage having desired voltage and frequency, and outputs the second alternating-current voltage to a motor; and a controller that controls an operation of the inverter. Capacitances of the reactor and the capacitor are set such that a resonance frequency of a filter circuit including the reactor and the capacitor is smaller than a first electrical angular frequency based on a voltage command when the controller controls an operation of the inverter such that the second alternating-current voltage is maximized in a range not causing overmodulation.
Abstract:
A power converter includes a converter circuit, a capacitor, and an inverter circuit. The converter circuit includes diodes that are connected in a half-bridge configuration. An alternating-current input end of the converter circuit is connected to one side of an alternating-current power supply. The inverter circuit includes semiconductor switching elements that are connected in a three-phase bridge configuration. An alternating-current output end of the inverter circuit is connected to a motor as a load, and an alternating-current output end is further connected to another side of the alternating-current power supply.
Abstract:
A power converter for converting a voltage of direct-current power output from a direct-current power supply, the power converter including: a printed circuit board; a reactor being configured with a conductor pattern of the printed circuit board; a semiconductor element that is connected to another end of the reactor and performs switching for storing electrical energy in the reactor so as to boost the voltage of the direct-current power from a first voltage to a second voltage; a capacitor that smooths the direct-current power boosted to the second voltage; a diode that is connected to the another end of the reactor and supplies the direct-current power boosted to the second voltage to the capacitor; and a cooler, wherein the reactor, the semiconductor element, and the diode are included in a module in a single package, and the module is cooled by the cooler.
Abstract:
A motor driving apparatus for driving a motor, the apparatus being connected to the motor by first, second, and third connection lines respectively corresponding to first, second, and third phases, the apparatus including: an inverter converting direct-current voltage into three-phase alternating-current voltage by using first, second, and third switching element pairs respectively connected to the first, second, and third connection lines, and outputting the three-phase alternating-current voltage to the motor; a voltage detection circuit detecting a first voltage based on a potential difference between a potential of the first connection line and a reference potential; and a control unit calculating a voltage value of the direct-current voltage based on the first voltage during a first period in which an upper-arm switching element of the first switching element pair is on, controlling operation of the inverter according to the voltage value, and changing the first period according to the voltage value.
Abstract:
An electric blower includes a fan, and a board disposed in an airflow path of the fan and including a switching element. The board includes a lead wire projecting into the airflow path.
Abstract:
In a motor driving apparatus including an inverter connectable to n motors (n being an integer not less than 2) each including a rotor having a permanent magnet, braking operation is performed on i (i being an integer from 1 to n−1) of the n motors, and then braking operation is performed on j (j being an integer from 1 to n−i) of the n motors other than the i motors. It is possible to reduce the risks of failure of the inverter and demagnetization of the motors due to overcurrent by reducing current flowing through the inverter and the motors when the braking operation is performed.