公开(公告)号：US06523528B1

公开(公告)日：2003-02-25

申请号：US09965859

申请日：2001-10-01

申请人： Leendert Wolters

发明人： Leendert Wolters

IPC分类号： F02M2102

CPC分类号： F02M21/0239 ,  F02D19/022 ,  F02D41/0027 ,  F02D41/2432 ,  F02D41/2464 ,  F02M21/047 ,  Y02T10/32

摘要： Gas metering system for an internal combustion engine. A gas pressure regulator is connected to a venturi located in the inlet of the internal combustion engine through a main adjusting screw being electrically adjustable. The control is provided in which engine rpm, load and mixture temperature are inputted. To provide for applicability for different types of engines and to obtain the ideal air fuel ratio for each operating condition, the control module of the adjustable main adjusting screw is provided with adjusting means. The surface area of the gas outflow openings in the venturi throat is the only required information for the control module to identify different types of engines and fuels and to adjust the gas flow automatically.

摘要翻译： 用于内燃机的气体计量系统 气体压力调节器通过电调节的主调节螺钉连接到位于内燃机入口的文丘里管。 提供了输入发动机转速，负载和混合气体温度的控制。 为了提供不同类型发动机的适用性并且为每个操作条件获得理想的空燃比，可调主调节螺杆的控制模块设有调节装置。 文丘里喉管中气体流出口的表面积是控制模块识别不同类型发动机和燃料以及自动调节气体流量的唯一必要信息。

公开(公告)号：US06314953B1

公开(公告)日：2001-11-13

申请号：US09500785

申请日：2000-02-09

申请人： Leendert Wolters

发明人： Leendert Wolters

IPC分类号： F02D4114

CPC分类号： F02D35/025 ,  F02D41/1497 ,  F02D2200/0406 ,  F02D2200/0414

摘要： Method and system for regulating the composition of an air/fuel stream supplied to an internal-combustion engine, comprise determining the mixture flow of the stream, the energy concentration of the air/fuel stream being measured and, from this, the desired mixture flow being determined and compared with the prevailing mixture flow and, if appropriate, correction of the air/fuel composition being carried out. Measuring the mixture strength may consist in the catalytic combustion of part of the mixture and determining the resulting temperature increase. The mixture flow can be determining by measuring the rotational speed of the engine and its inlet pressure and inlet temperature. Instead of comparing the determined and desired mixture flow, it is also possible to compare the prevailing and desired energy concentration and then to carry out a correction.

摘要翻译： 用于调节供应到内燃机的空气/燃料流的组成的方法和系统包括确定流的混合流量，正在测量的空气/燃料流的能量浓度，以及由此所需的混合流 被确定并与当前的混合物流量进行比较，并且如果合适的话进行空气/燃料组合物的校正。 测量混合物的强度可能包括部分混合物的催化燃烧，并确定所得的温度升高。 可以通过测量发动机的转速及其入口压力和入口温度来确定混合流量。 代替比较确定的和期望的混合流，也可以比较主要和期望的能量浓度，然后进行校正。

公开(公告)号：US20050161028A1

公开(公告)日：2005-07-28

申请号：US10763371

申请日：2004-01-23

申请人： Leendert Wolters

发明人： Leendert Wolters

IPC分类号： B01F5/04 ,  F02M21/04 ,  F02M25/07 ,  C10J1/00

CPC分类号： F02M21/042 ,  B01F5/0413 ,  B01F5/0426 ,  F02M21/047 ,  F02M26/19 ,  Y02T10/32 ,  Y10T137/87652

摘要： A gaseous fuel mixer includes a venturi defining a flow area that decreases from an inlet opening to a throat. The throat coincides with a minimum flow area of the venturi. The gaseous fuel mixer further includes a fuel delivery body in the flow area extending transverse to a longitudinal axis of the venturi and positioned between the throat and the inlet opening. The fuel delivery body is adapted to introduce gaseous fuel into the venturi at a trailing edge thereof opposite the inlet opening. The trailing edge of the fuel delivery body substantially coincides with the throat.

摘要翻译： 气体燃料混合器包括文氏管，其限定从入口开口到喉部减小的流动面积。 喉咙与文丘里管的最小流动面积重合。 气态燃料混合器还包括在流动区域中横向于文丘里管的纵向轴线延伸并且位于喉部和入口之间的燃料输送体。 燃料输送体适于在其与入口开口相对的后缘处将气体燃料引入文丘里管。 燃料输送体的后缘基本上与喉部重合。

公开(公告)号：US4517928A

公开(公告)日：1985-05-21

申请号：US519562

申请日：1983-08-02

申请人： Leendert Wolters

发明人： Leendert Wolters

IPC分类号： F02D19/00 ,  F02B3/06 ,  F02B47/00 ,  F02D19/10 ,  F02M1/16 ,  F02M21/00

CPC分类号： F02D19/0605 ,  F02D19/0678 ,  F02D19/0684 ,  F02D19/105 ,  F02B3/06 ,  Y02T10/36

摘要： A system for use of gas, like LPG, as secondary fuel in diesel engines is concerned. Normally aspirated and pressure charged engines with exhaust gas driven charging, with End-speed or All-speed governors or with common-rail-fuel injection systems are all included.A signal (24,25) proportional to the momentary effective fuel consumption controls the gas supply (20) to the engine (1). A valve (19) in the gas supply (18) is connected to the control lever (16) of the engine governor (12) to allow gas supply only in a load range above approximately 25% and up to a maximum of approximately 40% of the full load total fuel consumption. In the lower load range uncomplete combustion of the gas thus is avoided, in the higher load range both detonation and overload are avoided and the opacity of the exhaust is improved. The consumption of liquid fuel is reduced and the exhaust gas composition is improved. An adjustable stop (28,29) limits the maximum injectable liquid fuel quantity when the engine is operated in the dual-fuel-mode.The system is designed to be both retrofittable to existing engines and fittable to factory new engines.

摘要翻译： 关于使用气体（如LPG）作为柴油发动机中的二次燃料的系统。 通常带有排气驱动充气的吸气式和带压发动机，带有终速或全速调速器或共轨燃油喷射系统。 与瞬时有效燃料消耗成比例的信号（24,25）控制到发动机（1）的气体供应（20）。 气体供应装置（18）中的阀门（19）连接到发动机调速器（12）的控制杆（16），以允许仅在高于大约25％和高达大约40％ 的全负荷总燃料消耗。 在较低的负载范围内，避免了气体的不完全燃烧，因此在更高的负荷范围内，避免了爆震和过载，提高了排气的不透明度。 液体燃料的消耗减少，废气组成得到改善。 当发动机以双燃料模式运行时，可调停止（28,29）限制最大可注射液体燃料量。 该系统的设计既可以适应现有的发动机，也可以适应工厂新发动机。

公开(公告)号：US5657732A

公开(公告)日：1997-08-19

申请号：US587979

申请日：1996-01-17

申请人： Leendert Wolters ,  Johan Lugtenburg

发明人： Leendert Wolters ,  Johan Lugtenburg

IPC分类号： F02D45/00 ,  F02D35/02 ,  F02D41/00 ,  F02D41/04 ,  F02D41/14

CPC分类号： F02D41/1497 ,  F02D19/023 ,  F02D19/028 ,  F02D35/02 ,  F02D35/026 ,  F02D41/0025 ,  F02D41/0027 ,  Y02T10/32

摘要： Method and device for regulating the NO.sub.x emission of an internal combustion engine. It has been found that the NO.sub.x emission is dependent on the efficiency of the engine. That is to say the NO.sub.x emission can be optimized by determining and controlling the efficiency. This can be performed by making the measured and determined efficiencies equal to one another by altering the air/fuel ratio.

摘要翻译： 用于调节内燃机的NOx排放的方法和装置。 已经发现，NOx排放取决于发动机的效率。 也就是说，可以通过确定和控制效率来优化NOx排放。 这可以通过使测量和确定的效率通过改变空气/燃料比彼此相等来执行。

公开(公告)号：US5388607A

公开(公告)日：1995-02-14

申请号：US100561

申请日：1993-07-30

申请人： Antonius E. T. J. Ramaker ,  Leendert Wolters

发明人： Antonius E. T. J. Ramaker ,  Leendert Wolters

IPC分类号： F02D19/02 ,  F02M21/02 ,  F23N1/00 ,  F23N5/18 ,  G05D7/06

CPC分类号： F02M21/0239 ,  F02D19/023 ,  F02D19/027 ,  F02D19/028 ,  F02M21/0233 ,  F23N1/005 ,  F23N5/184 ,  F02M21/047 ,  F23N2025/04 ,  F23N2035/16 ,  Y02T10/32 ,  Y10S251/905 ,  Y10T137/2499 ,  Y10T137/776 ,  Y10T137/7761

摘要： A control system for supplying a gas flow to a gas consumption apparatus, comprising a gas supply pipe which can be connected to the apparatus and which has an electrically controlled gas control valve, and an electronic control unit. The control unit comprises a mathematical module, model-related to the control valve, for adjusting the valve position, and the gas control valve has in-built sensors for gas variables and valve position, the control system adjusting the control valve in linear proportion to a desired gas-flow signal to be supplied to the control unit. The mathematical module comprises a flow submodule, a mechanical submodule and a valve-position submodule, and the flow submodule receives, at its inputs, the desired gas-flow signal and gas variables originating from the valve sensors and supplies, at its output, a signal relating to the through-flow area of the valve, to the mechanical submodule. Said mechanical submodule contains mechanical valve parameters processed therein and supplies, at its output, a valve-position signal to the valve-position submodule, which receives a position signal originating from the valve-position sensor. The valve sensors for the gas variables comprise a sensor for the gas inlet pressure, a sensor for the gas inlet temperature and a sensor for the gas pressure difference across the valve. The gas control valve is designed as a cylindrical hollow slide valve having central gas feed and lateral gas outlet with exponential flow profile, and is provided with an electromagnetic actuator having a wire coil wound on the valve slide in a permanent magnetic field.

摘要翻译： 一种用于向气体消耗装置供应气流的控制系统，包括可连接到装置并具有电控气体控制阀的气体供应管和电子控制单元。 控制单元包括一个数学模块，与控制阀相关的模型，用于调节阀门位置，气体控制阀内置有用于气体变量和阀位置的传感器，控制系统将控制阀调整为线性比例 要供给控制单元的期望气流信号。 数学模块包括流量子模块，机械子模块和阀位子模块，流量子模块在其输入处接收期望的气体流量信号和源自阀传感器和供应源的气体变量，其输出端 与阀的通流区域相关的信号传递到机械子模块。 所述机械子模块包含在其中处理的机械阀参数，并在其输出端向阀位置子模块提供阀位置信号，该阀位置子模块接收来自阀位置传感器的位置信号。 用于气体变量的阀传感器包括用于气体入口压力的传感器，用于气体入口温度的传感器和用于气体压差差异的传感器。 气体控制阀被设计为具有中心气体进料和具有指数流量分布的侧向气体出口的圆柱形中空滑阀，并且具有在永久磁场中缠绕在阀滑块上的线圈的电磁致动器。