SYSTEMS AND METHODS FOR ESTABLISHING A DIAGNOSTIC TRANSMISSION MODE AND COMMUNICATING OVER THE SAME
    9.
    发明申请
    SYSTEMS AND METHODS FOR ESTABLISHING A DIAGNOSTIC TRANSMISSION MODE AND COMMUNICATING OVER THE SAME 审中-公开
    用于建立诊断传输模式和通信的系统和方法

    公开(公告)号:US20170034343A1

    公开(公告)日:2017-02-02

    申请号:US15295602

    申请日:2016-10-17

    申请人: TQ DELTA, LLC

    摘要: Upon detection of a trigger, such as the exceeding of an error threshold or the direction of a user, a diagnostic link system enters a diagnostic information transmission mode. This diagnostic information transmission mode allows for two modems to exchange diagnostic and/or test information that may not otherwise be exchangeable during normal communication. The diagnostic information transmission mode is initiated by transmitting an initiate diagnostic link mode message to a receiving modem accompanied by a cyclic redundancy check (CRC). The receiving modem determines, based on the CRC, if a robust communications channel is present. If a robust communications channel is present, the two modems can initiate exchange of the diagnostic and/or test information. Otherwise, the transmission power of the transmitting modem is increased and the initiate diagnostic link mode message re-transmitted to the receiving modem until the CRC is determined to be correct.

    摘要翻译: 在检测到诸如超过错误阈值或用户方向的触发时,诊断链路系统进入诊断信息传输模式。 该诊断信息传输模式允许两个调制解调器交换在正常通信期间可能不可交换的诊断和/或测试信息。 通过向伴随循环冗余校验(CRC)的接收调制解调器发送初始诊断链路模式消息来启动诊断信息传输模式。 接收调制解调器基于CRC确定是否存在健壮的通信信道。 如果存在健壮的通信信道,则两个调制解调器可以发起诊断和/或测试信息的交换。 否则,发送调制解调器的发送功率增加,并且初始诊断链路模式消息被重新发送到接收调制解调器,直到CRC被确定为正确。

    Method and apparatus for analyzing and mitigating noise in a digital subscriber line
    10.
    发明授权
    Method and apparatus for analyzing and mitigating noise in a digital subscriber line 有权
    用于分析和减轻数字用户线路中的噪声的方法和装置

    公开(公告)号:US09391744B2

    公开(公告)日:2016-07-12

    申请号:US14162133

    申请日:2014-01-23

    摘要: Data indicative of a level of stability of a DSL link is received. Based on the received data, it is determined whether the data indicates a level of stability of the DSL link that is above or below and minimum threshold. If the level of stability of the DSL link is below the minimum threshold, die noise associated with the DSL link before the time of failure is compared with the noise of failure. If the difference between the noise before and after the time of failure exceeds a threshold, then the difference in noise is characterized as a stationary noise associated with the DSL link. However, if the difference between the noise before and after the time of failure is below the threshold, a determination is made whether the failure is associated with a loss of power to the DSL link or a severe impulse noise event the difference in noise is characterized accordingly. Finally, the characterization of the noise associated with the DSL link is preserved for subsequent possible reconfiguration of the DSL link to improve link stability.

    摘要翻译: 接收到指示DSL链路的稳定性水平的数据。 基于接收到的数据,确定数据是否指示DSL链路的稳定度高于或低于最小阈值。 如果DSL链路的稳定度低于最小阈值,则与故障之前的DSL链路相关联的模块噪声与故障噪声进行比较。 如果故障之前和之后的噪声之间的差异超过阈值,则噪声的差异被表征为与DSL链路相关联的稳定的噪声。 然而,如果故障之前和之后的噪声之间的差异低于阈值,则确定故障是否与DSL链路的功率损耗相关联或严重脉冲噪声事件,噪声的差异被表征 相应地。 最后,保留与DSL链路相关联的噪声的表征,以便随后可能重新配置DSL链路以改善链路稳定性。