摘要:
A wireless power receiver IC in which the power path can be reconfigured as either a low-dropout regulator (LDO), a switched-mode power supply (SMPS) or a power switch (PSW) is provided. All three modes share the same pass device to reduce die area and share the same output terminal to reduce pin. In an inductive wireless receiver, the power path can be reprogrammed on the fly to LDO or PSW mode or can be reprogrammed on the fly to SMPS or PSW mode. In a resonant or multi-mode wireless receiver, the power path can be reprogrammed on the fly to SMPS or PSW mode. Furthermore, to achieve high power transfer efficiency performance, using N-channel MOSFET as its pass device has better efficiency and smaller die area than P-channel MOSFET pass device.
摘要:
A wireless charging in-band communication system includes a channel encoding for message error correction and detection. A modulation module performs biphase modulation for DC balanced signals and impedance switching to change reflected impedance seen by the source. A synchronization module prepends the message with a synchronization sequence having Golay complementary codes. A receiver module receives the message from the transmitter module. A preamble detection block has a Golay complementary code correlator used for message detection, synchronization, and equalization coefficient estimation and selection. A decoding module that performs biphase demodulation with error correction with a DC offset being estimated as the average value of the signal over the length of the message before channel decoding. The decoding module performs equalization, error correction and detection channel decoding.
摘要:
A synchronous rectifier using only n-channel devices in which the low-side switches are effectively cross-coupled using low-side comparators and the high-side switches perform an accurate zero-voltage-switching (ZVS) comparison. The charging path of each bootstrap domain is completed through the low-side switches, which are each always on for every half-cycle independent of loading. This scheme gives rectifier efficiency gain because a) each bootstrap domain receives maximum charging time, and b) the charging occurs through a switch rather than a diode. Both these factors ensure the bootstrap domain is fully charged, thereby reducing conduction losses through the rectifier switches. Furthermore, settings may be adjusted by software to optimize the resistive and capacitive losses of the rectifier. Using data for die temperature and operating frequency, software can create a feedback loop, dynamically adjusting rectifier settings in order to achieve the best possible efficiency.
摘要:
A resonant wireless power (RWP) receiver is provided that includes an inductor element that couples with a resonant wireless power source. A capacitor arrangement is coupled to the inductor element altering the open-circuit impedance of the RWP receiver to reduce the ac voltage under certain defined situations. The capacitor arrangement includes a plurality capacitors tuned to a control ac voltage in the RWP receiver.
摘要:
A wireless charging system is provided that includes a charger portion that receives one or more portable elements for charging wirelessly. The charger portion controls the amount of power needed to charge the one or more portable elements. An inband communication module receives inband communications with the one or more portable elements using a random access mode. The charger portion utilizes the inband communications to determine how much power is needed, via energy based reporting, to charge the one or more portable elements that avoids conveying identification information.
摘要:
Some embodiments relate to a system that includes a first device which is a wireless power transmitter or mobile device and a power adapter external to the first device. The power adapter is configured to receive a control signal and to control a DC output voltage of the power adapter based upon the control signal. The first device is configured to send the control signal to the power adapter.
摘要:
A synchronous rectifier using only n-channel devices in which the low-side switches are effectively cross-coupled using low-side comparators and the high-side switches perform an accurate zero-voltage-switching (ZVS) comparison. The charging path of each bootstrap domain is completed through the low-side switches, which are each always on for every half-cycle independent of loading. This scheme gives rectifier efficiency gain because a) each bootstrap domain receives maximum charging time, and b) the charging occurs through a switch rather than a diode. Both these factors ensure the bootstrap domain is fully charged, thereby reducing conduction losses through the rectifier switches. Furthermore, settings may be adjusted by software to optimize the resistive and capacitive losses of the rectifier. Using data for die temperature and operating frequency, software can create a feedback loop, dynamically adjusting rectifier settings in order to achieve the best possible efficiency.
摘要:
Some embodiments relate to a system that includes a first device which is a wireless power transmitter or mobile device and a power adapter external to the first device. The power adapter is configured to receive a control signal and to control a DC output voltage of the power adapter based upon the control signal. The first device is configured to send the control signal to the power adapter.
摘要:
A resonant wireless power (RWP) receiver is provided that includes an inductor element that couples with a resonant wireless power source. A capacitor arrangement is coupled to the inductor element altering the open-circuit impedance of the RWP receiver to reduce the ac voltage under certain defined situations. The capacitor arrangement includes a plurality capacitors tuned to a control ac voltage in the RWP receiver.
摘要:
A resonant wireless power receiver that includes an electromagnetic resonator having one or more inductive elements that are arranged to form a receiver coil and a network of passive components arranged to form a matching network. A rectifier circuit converts ac power from the electromagnetic resonator to dc power. An available-power indicator measures the rectified power to assess the instantaneous power available to the receiver.