摘要:
In carrying out electric discharge machining of a graphite or carbon-composite workpiece by a wire electric discharge machine, a voltage lower than that used in machining a metal workpiece by the wire electric discharge machine is supplied to a machining gap. Further, the peak value and the pulse width of a total discharge current flowing from a power supply device for electric discharge machining to a wire electrode are adjusted within ranges of 30 to 150 amperes and 0.3 to 6.4 microseconds, respectively.
摘要:
A measurement program for sequentially measuring measurement points, which are to be measured with a touch sensor, is created on the basis of a machining program, which is read in, for machining a turning tool. Then, the rake face height is measured on each of the measurement points and the measurement data is stored. Subsequently, a calculation method of a correction amount is selected so as to calculate the correction amount, and whether or not the calculated correction amount is smaller than a regulation value is determined. The machining program is modified on the basis of the correction amount when the correction amount is not smaller than the regulation value, while the machining program is modified on the basis of the correction amount in accordance with the selected method when the correction amount is smaller than the regulation value.
摘要:
In a wire electric discharge machine or an automatic programming device for a wire electric discharge machine, in which a core is held with a workpiece base material by attaching brass contained in a wire electrode to the machining groove during machining, an attachment/deposition region where machining chips containing brass produced during machining are attached and deposited to the workpiece is set based on a machining shape obtained from a machining program and the machining chips containing brass produced during machining are attached and deposited according to the set attachment/deposition region.
摘要:
A measurement program for sequentially measuring measurement points, which are to be measured with a touch sensor, is created on the basis of a machining program, which is read in, for machining a turning tool. Then, the rake face height is measured on each of the measurement points and the measurement data is stored. Subsequently, a calculation method of a correction amount is selected so as to calculate the correction amount, and whether or not the calculated correction amount is smaller than a regulation value is determined. The machining program is modified on the basis of the correction amount when the correction amount is not smaller than the regulation value, while the machining program is modified on the basis of the correction amount in accordance with the selected method when the correction amount is smaller than the regulation value.
摘要:
In the wire electric discharge machine, a heat resistant tube in which a wire electrode is inserted and a coil which is wound around the heat resistant tube and causes high frequency dielectric heating are arranged on a downstream side of a device which applies the tension to a wire electrode led from a wire bobbin but on the upstream side of an upper guide portion. Further, a turn density of the coil in a section (annealing section) of the heat resistant tube close to the inlet of the wire electrode is made lower than a coil turns density in a section (fusing and cutting section) close to an outlet of the wire electrode.