摘要:
An image display device includes two data signal line drive circuits and two scan signal line drive circuits configured differently from each other. Different data signal line drive circuits and scan signal line drive circuit are compatible with different display formats. A display can be produced in the most suitable display format, and power consumption also can be reduced, by switch operating drive circuits according to the kind of input video and environmental conditions. Further, an image can be written over another image by writing video signals to signal lines with a time lag using a plurality of drive circuits; therefore, a superimposed display can be produced without externally processing the video signals. Thus, both a satisfactory image display and low power consumption can be achieved in an image display device.
摘要:
An image display device includes two data signal line drive circuits and two scan signal line drive circuits configured differently from each other. Different data signal line drive circuits and scan signal line drive circuit are compatible with different display formats. A display can be produced in the most suitable display format, and power consumption also can be reduced, by switch operating drive circuits according to the kind of input video and environmental conditions. Further, an image can be written over another image by writing video signals to signal lines with a time lag using a plurality of drive circuits; therefore, a superimposed display can be produced without externally processing the video signals. Thus, both a satisfactory image display and low power consumption can be achieved in an image display device.
摘要:
A signal line driving circuit includes a shift register having a plurality of shift circuits, each of which shifts a start pulse successively to the next stage, synchronizing with the timing of a clock signal. In this signal line driving circuit, shift pulses are outputted from an AND gate based on output pulses of two adjacent shift circuits. Meanwhile, a width specifying pulse for specifying a pulse width of the shift pulse is inputted via a transistor whose ON/OFF operation is controlled by the shift pulse. A logical operation circuit operates an AND of the shift pulse and the width specifying pulse and outputs the result of operation to a signal line. When the shift pulse is non-active, the transistor becomes OFF, which causes the signal line transmitting the width specifying pulse to be disconnected from the signal line driving circuit, thereby reducing a capacitive load of wiring. As a result, reduction of a parasitic capacitance of the wiring, reduction in the number of elements, reduction in the size of an amplitude of an input signal, etc. in the signal line driving circuit are attained.
摘要:
An image display device includes two data signal line drive circuits and two scan signal line drive circuits configured differently from each other. Different data signal line drive circuits and scan signal line drive circuit are compatible with different display formats. A display can be produced in the most suitable display format, and power consumption also can be reduced, by switch operating drive circuits according to the kind of input video and environmental conditions. Further, an image can be written over another image by writing video signals to signal lines with a time lag using a plurality of drive circuits; therefore, a superimposed display can be produced without externally processing the video signals. Thus, both a satisfactory image display and low power consumption can be achieved in an image display device.
摘要:
A level shifter 13 is provided for each of SR flip flops F1 constituting a shift register 11. The level shifter 13 increases a voltage of a clock signal CK. This arrangement reduces a distance for transmitting a clock signal whose voltage has been increased, as compared with a construction in which a voltage of a clock signal is increased by a single level shifter and the signal is transmitted to each of the flip flops; consequently, a load capacity of the level shifter can be smaller. Furthermore, each of the level shifters is operated during a pulse output of the previous level shifter 13, and the operation is suspended at the end of the pulse output. Thus, the level shifters 13 can operate only when it is necessary to apply a clock signal CK to the corresponding SR flip flop F1. As a result, even when an amplitude of a clock signal is small, it is possible to reduce power consumption of the shift resister under normal operation.
摘要:
A shift register circuit includes a plurality of latch circuits connected in series to sequentially transfer a pulse signal ST from one to another, a clock signal line transmitting a clock signal CLK, and a plurality of switching circuits performing electrical connection and disconnection between the clock signal line and the plurality of latch circuits. Upon turning on the shift register, at least one of the switching circuits electrically disconnects at least one of the latch circuits from the clock signal line. During an initialization period immediately after power has been turned on, the frequency of the clock signal CLK is lower than in a normal operation period and gradually increases toward the frequency used in the normal operation period.
摘要:
A digital-to-analog conversion circuit of charge distribution type includes a plurality of capacitors having respective capacitances that increase in a sequential order, one end of the capacitors being commonly connected electrically. The circuit also includes a plurality of analog switches each for electrically connecting a reference potential corresponding to a digital signal inputted from outside to the other end of the corresponding capacitor. These analog switches have respective driving capacities that increase in a sequential order.
摘要:
A digital/analogue converter for converting an input n-bit digital code, where n is an integer greater than one, has an n-bit digital input and an output for connection to a load, and includes: an array of (n−1) switched capacitors; and a switching arrangement. In one example embodiment, the switching arrangement is adapted, in a zeroing phase of operation, to connect a first reference voltage to the first plate of at least one capacitor of the array and to connect a second plate of the at least one capacitor to a voltage that, for at least one value of the input digital code, is different from the first reference voltage and is further adapted, in a decoding phase of operation, to enable, dependent on the value of the input digital code, injection of charge into the at least one capacitor. In one example embodiment, the converter may be a bufferless converter having an output for direct connection to a capacitive load.
摘要:
A CMOS logical circuit comprises two electric current paths each of which has circuits consisting of n-type and p-type transistors. In a circuit consisting of n-type or p-type transistors, one electric current path is provided with a circuit having the same construction as that of a circuit having an n-type transistor of a CMOS logical circuit outputting a logical operation result similar to that of this logical circuit, and the other electric current path is provided with a circuit having the same construction as that of a circuit having a p-type transistor of the CMOS logical circuit outputting a logical operation result similar to that of this logical circuit. In another circuit consisting of the other channel type, a gate electrode of the transistor provided on the one electric current path and that of the transistor provided on the other electric current path are connected to drain electrodes of the counterparts. According to the construction, the amplitude of an input signal can be made smaller than a supply voltage of the logical circuit.
摘要:
Before a potential of counter electrode is changed, a potential holding circuit fixedly holds potentials of data signal lines S during a non-selective period of scanning signal lines G. This prevents the potentials of the data signal lines S from being an undesirably large potential, which is caused by coupling capacitors between the counter electrode and each data signal line S, whereby it is possible to supply to the pixel capacitor an electric charge corresponding to a gradation to be displayed, by using the relatively low potentials of the data signal lines S. This lowers a power supply voltage of a data signal driving circuit SD, thus reducing the electric power consumption. In short, with this arrangement, a liquid crystal display device can perform an opposed AC drive for line-inversion drive, frame-inversion drive and the like, by low power supply voltage of the data signal line driving circuit SD, thereby reducing the electric power consumption.