摘要:
44Gate potentials of transistors Q.sub.R0 and Q.sub.R1 provided in an active pull-up circuit APo are always controlled to be appropriate values by a clock signal .phi..sub.p. As a result, reverse flow of electric charge from a capacitor C.sub.R0 or C.sub.R1 to a bit line LB or BL can be prevented and unfavorable influence due to such reverse flow of electric charge can be avoided in operation of the active pull-up circuit APo.
摘要:
A semiconductor memory device comprises a data input switching circuit (20) connected between the output side of a write check bit generating circuit (2) and the input side of a check bit memory cell array (32), a data output switching circuit (30) connected to the input side of an address decoder (9), and an address switching circuit (10) connected to the output side of the address decoder (9). When a test mode is entered, the data input switching circuit (2), data output switching circuit (30) and address switching circuit (10) connect a data input signal line (l), data output signal line (m) and address signal line (n), respectively, to the check bit memory cell array (32), enabling the check bit memory cell array (32) to be accessed from the outside.
摘要:
A cut-off clock .phi..sub.5 generated by a cut-off clock generation circuit PG is supplied to a decode circuit DEC. The decode circuit DEC decodes the cut-off clock .phi..sub.5 to produce two types of cut-off clocks .phi..sub.5L and .phi..sub.5R. The two types of cut-off clocks .phi..sub.5L and .phi..sub.5R are supplied to a control clock generation circuit as shown in FIG. 3 or 11, which in turn produces control clocks .phi..sub.2L and .phi..sub.2R. The control clocks .phi..sub.2L and .phi..sub.2R are supplied to a shared sense amplifier of FIG. 1, to control on-off operations of transfer transistors 7.sub.L, 8.sub.L, 7.sub.R and 8.sub.R.
摘要:
A circuit for generating a boosted signal for a word line, coupled to a word line driving signal line for transmitting a voltage signal to the word line, coupled to a first power supply, and coupled to a second power supply for providing a voltage higher than the voltage of the first power supply, can supply a compensating voltage for the word line from the second power supply through the word line driving signal line when a voltage of the word line is decreased.
摘要:
A dynamic type MOS-RAM constructed of folded type bit lines and having sense operation cycles for amplifying potential difference appearing on respective pairs of bit lines after selection of a word line and restore operation cycles for further amplifying the potential difference on the pairs of bit lines after the sense operation cycles, wherein non-selected word lines are completely brought into electrically floating states in intervals including the sense operation cycles and the restore operation cycles.
摘要:
A semiconductor memory comprises memory cells (15-18, 27-30), a data writing terminal (1), a data readout terminal (48), transistors (3-10, 35-42), address signal input terminals (23-26), subdecode signal input terminals (43-46), driving signal generating circuits (49-52), parallel readout circuits (79-82) and test mode switching signal input terminal (53, 88). In writing of function test data for the memory cells, the driving signal generating circuits turn all of the transistors (3-10) on in response to a test mode switching signal with no regard to address signals, thereby to simultaneously write data in the memory cells (15-18). Further, in readout of the function test data for the memory cells, the parallel readout circuits read the storage contents of the memory cells (27-30) storing the test data in response to a test mode switching signal with no regard to subdecode signals. Logic circuit means (90, 91, 94) may be provided to output logical value corresponding to the test data stored in the memory cells when all of the logical values of the test data are at the same level.
摘要:
A MOS dynamic type RAM comprises memory cells (10), dummy cells (11), bit line pairs (BL, BL), word lines (WL), dummy word lines (DWL) and sense amplifiers (12). In a non-active cycle, the potentials of each pair of bit lines (BL, BL) are precharged at 1/2 of a supply potential V.sub.CC. Each sense amplifier (12) operates in an active cycle following the non-active cycle, while each active pull-up circuit (13) pulls up the potential of a higher level one of the pair of bit lines to V.sub.CC. This active cycle is defined by an internal RAS internal signal, which is generated by a NAND circuit (27) in response to an external RAS signal and an RPW signal obtained by delaying the external RAS signal by a delay circuit (20) and having a trailing edge obtained by delaying the trailing edge of the external RAS signal by a prescribed period.
摘要:
A semiconductor memory comprises a data bit memory cell array (3), a check bit memory cell array (4), and an address decoder (19) which includes a switching circuit (20) for selectively accessing data from either the memory cell array (3) or (4). Decoding signals d.sub.l to d.sub.m are used for reading out data latched by a column address strobe (CAS) signal. The decoding signals are applied to either the memory cell array (3) or (4) through a group of switching elements selectively rendered conductive by complementary signals .phi. and .phi.. The logical values of the signals .phi. and .phi. change responsive to a change in the CAS signal state.
摘要:
A dynamic RAM has dummy capacitors (C6, C7) having the same capacitance as a memory capacitor connected to a pair of bit lines (BL1, BL1), respectively. During an active period, respective dummy capacitors (C6, C7) are charged to the H level and L level, which are signal levels of the bit lines (BL1, BL1) and during precharge period, both dummy capacitors are equalized. Since both dummy capacitors (C6, C7) respectively connected to a pair of bit lines (BL1, BL1) are equalized during precharge period, so that the stored charge values of the dummy capacitors (C6, C7) both become the intermediate value of the ground level and supply potential level.
摘要:
A semiconductor memory device is operable selectively in a page mode or a nibble mode, depending upon an external mode selection signal. In the page mode of operation a row address is supplied to the memory with subsequently supplied column addresses corresponding on a one-to-one basis with data to be stored into or read from memory. In the nibble mode of operation, the memory sequentially reads from or writes to four adjacent memory cells for each column address supplied.