摘要:
A system for improving the management and usage of blocks based on intrinsic endurance may be used to improve memory usage for flash memory, such as a memory card. The overall card endurance may be extended by cycling blocks with higher intrinsic endurance over the lowest endurance target of the worst block. This may be accomplished by managing blocks with different intrinsic endurance values internally or by partitioning the blocks with different intrinsic endurance values externally for different usage.
摘要:
A non-volatile memory with multiple memory dice manages simultaneous operations so as to not exceed a system power capacity. A load signal bus is pulled up with a strength proportional to the system power capacity. Each die has a driver to pull down the bus by an amount corresponding to its degree of power need as estimated by a state machine of the die. The bus therefore provides a load signal that serves as arbitration between the system power capacity and the cumulative loads of the individual dice. The load signal is therefore at a high state when the system power capacity is not exceeded; otherwise it is at a low state. When a die wishes to perform an operation and requests a certain amount of power, it drives the bus accordingly and its state machine either proceeds with the operation or not, depending on the load signal.
摘要:
A method and system have been described for counteracting and correcting for read disturb effects in blocks of flash memory. The method may include the step of a controller of the memory system performing a read scrub scan on only a portion of one targeted word line in a block at desired intervals. The controller may calculate whether a read scrub scan is necessary based on a probabilistic determination that is calculated in response to each received host read command. The controller may then place a block associated with the targeted word line into a refresh queue if a number of errors are detected in the targeted word line that meets or exceeds a predetermined threshold. The block refresh process may include copying the data from the block into a new block during a background operation.
摘要:
A system for grading blocks may be used to improve memory usage. Blocks of memory, such as on a flash card, may be graded on a sliding scale that may identify a level of “goodness” or a level of “badness” for each block rather than a binary good or bad identification. This grading system may utilize at least three tiers of grades which may improve efficiency by better utilizing each block based on the individual grades for each block. The block leveling grading system may be used for optimizing the competing needs of minimizing yield loss while minimizing testing defect escapes.
摘要:
Non-voltage storage and techniques for fabricating non-volatile storage are disclosed. In some embodiments, at least a portion of the control gates of non-volatile storage elements are formed from p-type polysilicon. In one embodiment, a lower portion of the control gate is p-type polysilicon. The upper portion of the control gate could be p-type polysilicon, n-type polysilicon, metal, metal nitride, etc. P-type polysilicon in the control gate may not deplete even at high Vpgm. Therefore, a number of problems that could occur if the control gate depleted are mitigated. For example, a memory cell having a control gate that is at least partially p-type polysilicon might be programmed with a lower Vpgm than a memory cell formed from n-type polysilicon.
摘要:
A plurality of non-volatile storage elements on a common active layer are offset from neighbor non-volatile storage elements. This offsetting of non-volatile storage elements helps reduce interference from neighbor non-volatile storage elements. A method of manufacture is also described for fabricating the offset non-volatile storage elements.
摘要:
Dynamically determining read levels on chip (e.g., memory die) is disclosed herein. One method comprises reading a group of non-volatile storage elements on a memory die at a first set of read levels. Results of the two most recent of the read levels are stored on the memory die. A count of how many of the non-volatile storage elements in the group showed a different result between the reads for the two most recent read levels is determined. The determining is performed on the memory die using the results stored on the memory die. A dynamic read level is determined for distinguishing between a first pair of adjacent data states of the plurality of data states based on the read level when the count reaches a pre-determined criterion. Note that the read level may be dynamically determined on the memory die.
摘要:
Systems and methods are disclosed that are responsive to a rate of change of a performance parameter of a memory. In a particular embodiment, a rate of change of a performance parameter of a non-volatile memory is determined. The rate of change is compared to a threshold, and an action is performed in response to determining that the rate of change satisfies the threshold.
摘要:
A system for programming non-volatile storage is proposed that reduces the impact of interference from the boosting of neighbors. Memory cells are divided into two or more groups. In one example, the memory cells are divided into odd and even memory cells; however, other groupings can also be used. Prior to a first trigger, a first group of memory cells are programmed together with a second group of memory cells. Subsequent to the first trigger and prior to a second trigger, the first group of memory cells are programmed separately from the second group of memory cells. Subsequent to the second trigger, the first group of memory cells are programmed together with the second group of memory cells. Before and after both triggers, the first group of memory cells are verified together with the second group of memory cells.
摘要:
A system for programming non-volatile storage is proposed that reduces the impact of interference from the boosting of neighbors. Memory cells are divided into two or more groups. In one example, the memory cells are divided into odd and even memory cells; however, other groupings can also be used. Prior to a first trigger, a first group of memory cells are programmed together with a second group of memory cells. Subsequent to the first trigger and prior to a second trigger, the first group of memory cells are programmed separately from the second group of memory cells. Subsequent to the second trigger, the first group of memory cells are programmed together with the second group of memory cells. Before and after both triggers, the first group of memory cells are verified together with the second group of memory cells.